Do Sendel Aluminum Trailer Wheels Require Different Lug Nuts

Question

Question:

do i need different lug nuts for this wheel

asked by: George W

0

Expert Reply:

Hey George, the Aluminum Sendel Series 03 wheel part # SEN34FR that you referenced has steel inserts for where the lug nuts attach to the wheel so you wouldn't need to use any special lug nuts. Standard lug nuts would work just fine. I like to recommend one piece stainless steel lug nuts like the part # DE55KR as they don't corrode or swell so they are easy to deal with and won't give you issues down the road.

expert reply by: Jameson C

0

George W.

1/28/2026

will i need to change the length of the wheel studs

Jameson C.

1/28/2026

@GeorgeW no you would not. These wheels are designed to be used with standard length studs.

Answer 1

We have the Seal Puller #PTW1219 for removing the grease seal on the back of the hub to make removing the inner bearing easier. The 7-Piece Installation Set for Bearings, Races, and Seals #PTW83020 is only used when installing the bearing races and…

view full answer...

Answer 2

Hey Eric! The limitation on the Aluminum Siberian Trailer Wheel #LH78MR is the valve stem. The max psi for this valve stem is 100 psi so that would be the limit. If the max psi of the tires is higher, you can swap out the valve stem for the Americana…

view full answer...

Answer 3

Based off the measurements you provided, you've got a #84 spindle, so the correct bearings are the #L44649 and #L68149, and #RG06-050 grease seals. We typically try to put bearing numbers of popular manufacturers on the bearing pages but those…

view full answer...

Answer 4

Hey Trailer Dude! The Aluminum Sendel Series 03 Trailer Wheel #SEN34FR that you referenced has a zero offset like most trailer wheels have.

view full answer...

Answer 5

I may have a solution for you, but the 1a-v-1260ar part number you've mentioned corresponds to a Kaper II marker lamp, which is a brand that we do not carry. However, it looks like the Optronics Thinline LED Trailer Fender Light for Trailers Over…

view full answer...

Answer 6

It won't work unless your 8k axles are 3 inch in diameter which is sometimes the case. The Roadmaster Comfort Ride part #RM-2460-2580 won't work on a 3.5 inch diameter axle.

view full answer...