Replacement Wiring for Lippert Ground Control 3.0
Updated 12/08/2025 | Published 11/28/2025
Products Featured in This Question
Question:
Got a rat problem. Need to replace the wiring harnesses on RR and LR jacks. Might well include the sensor harness. Can you provide me with the part numbers for these cables?
asked by: Travis W
0
Expert Reply:
Hi Travis, welcome back! Sorry to hear about your rat problem. The left rear wiring harness is the # LC65ED and the right rear is the # LC347012. The rear sensor harness is the Lippert Hall Effect Sensor-to-Control-Board Harness # LC82AF. I attached the wiring diagram below for your reference, let me know if you need anything else.
expert reply by:
Robin H
0
Wiring Diagram
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: suburban furnace
- Video: Review of Lippert Hall Effect Sensor To Control Board Harness - LC82AF
- Search Results: wiring harness flat tow wiring harness
- Search Results: lc346005
- Shop: Replacement Hall Effects Wiring Harness - Right Side
- Shop: Lippert Hall Effect Sensor-to-Control-Board Harness
- Shop: Replacement Hall Effect Sensor Wire Harness for Lippert Ground Control 3.0 - Rear Driver's Side
- Shop: Replacement Hall Effects Wiring Harness - Left Side
- Video: What to Know About the Replacement Hall Effects Wiring Harness
- Q&A: Lippert Electric A-Frame Trailer Jack 1817941 Stripped Threads on Screw/Nut
- Shop: Replacement Hall Effect Sensor Wire Harness Ground Control 3.0 - Passenger's Side Front
- Shop: Lippert Replacement Motor Harness for RV In-Wall Slide-Out - 25' Long
- Shop: Dometic RV Furnace Access Door - 19" Long x 11-1/2" Tall - Black
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: How Can I Lock My Watchdog Power Center Surge Protector and Voltage Booster to Pedestal?
- Q&A: Will Turn Signals Activate Side Cameras of Furrion Vision S+ System
- Q&A: Do Lithium Batteries Need to be In Different Compartment from Inverter
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: Replacement Control Module for Lippert Ground Control 3.0
- Q&A: Upgrading Pin Box to the Curt Trailair Rota-Flex 5th Wheel Pin Box
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
Robin H.
12/8/2025
Hey Travis, how did things go with the new wiring harnesses for your Ground Control 3.0 jacks? Your update could make it easier for the next person dealing with the same repair.