Do All Of The Thomas Payne TriFold Loveseats 68" Wide Have the Same Frame And Footprint?

Question

Question:

Is the Cobblestone loveseat LC54FC built on the same Rest Easy frame as the McCoy and Driftwood versions?

asked by: Sean

0

Expert Reply:

Exactly right, Sean - the Bowery Cobblestone trifold # LC54FC shares the same Lippert Rest Easy steel frame and fold-out mechanism used on the McCoy # TP79KR, Driftwood # TP69KR, and Dellmead # TP49KR models. The only difference is the gray leather-look finish, so you get identical dimensions (68" W × 33-1/2" D × 36" H) and the same smooth 3-step bed conversion. All four colors match perfectly in height and mounting style.

What color scheme are you going for in your rig’s living area?

expert reply by: Andrew N

0

Driftwood
(click to enlarge)

Cobblestone
(click to enlarge)

McCoy
(click to enlarge)

Dellmead
(click to enlarge)

Sean

11/12/2025

Perfect, thanks Andrew. I was mainly checking because our old Cobblestone folds tight against the wall. wanted to be sure the McCoy would too.

Andrew N.

11/12/2025

@Sean Yep, you’re safe there, Sean - identical frame and everything. The only differences are upholstery and trim. If your Cobblestone cleared before, the McCoy or Driftwood will fit exactly the same. Are you remodeling the whole RV or just changing up the material/color of the loveseat this time around?

Sean

11/12/2025

@AndrewN remodeling a bit! this goes better with the entertainment center / fireplace we picked out.

Andrew N.

11/12/2025

@Sean Nice! I bet that is looking great.

Answer 1

Hey John, the Thomas Payne Trifold RV Loveseat part #LC72PX that you referenced weighs 147 lbs. It does come apart into sections to make it easier to get inside the RV as well.

view full answer...

Answer 2

You’re safe, Mike. The 68" wide Thomas Payne Rest Easy Trifold loveseat - whether it’s the Dellmead #TP49KR, Driftwood #TP69KR, or McCoy #TP79KR, no-wall-clearance is required, meaning the bed folds forward into the room instead of back. That’s…

view full answer...

Answer 3

Hey, Linda. After doing a bit of digging and research, I found that the Thomas Payne Trifold RV Loveseat in Seaport Mink, part #LC94FC, is made with PolyHyde material, which is known for its durability and easy-to-clean surface. It’s also backed by a…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Do All Of The Thomas Payne TriFold Loveseats 68" Wide Have the Same Frame And Footprint?

Products Featured in This Question

Continue Researching