Looking For New Hangers For Small Boat Trailer With Leaf Springs With Radius End?
Updated 10/21/2025 | Published 10/17/2025 >
Question:
hi there, i have a small boat trailer with leaf springs with the radius arms. i dont believe my trailer has the propper hangers for the radius arms. Could i send u a pic so i can start in the right directions to replace them? thanks!
asked by: Daniel B
Expert Reply:
Hello Daniel, thanks for reaching out. There is no way to add pictures to the comments on here but you can email them to me. My email is [email protected]. Send those over and I am happy to take a look.
Are you wanting to replace just the hangers? Or are you needing new springs too?
If you need springs I will need to know the weight capacity of your axle, as well as the length of your springs. The springs should be measured unloaded from the center of the hole to end of the radius end.
Let me know if there are any other parts you are needing or if there is anything else I can do to help.
Product Page this Question was Asked From
Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 38" Axle Spacing
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 2 Inch
- Tandem Axle
- Dexter
more information >
Continue Researching
- Search Results: slipper
- Video: Detailed Breakdown of the Shackle Bolt with Locknut For Double-Eye Springs
- Shop: CE Smith 24-5/8" Slipper Leaf Spring - 250 lb Load - 1-3/4" Wide - Single Leaf - Steel
- Search Results: slipper spring hanger kit
- Video: Review of CE Smith Trailer Leaf Springs - Slipper Springs - CES73JR
- Search Results: double eye
- Search Results: slipper spring
- Search Results: slipper leaf spring
- Shop: Shackle Bolt with Locknut For Double-Eye Springs - 1/2" Diameter - 3" Long
- Search Results: hangar
- Search Results: hanger
- Shop: Single-Axle Trailer Hanger Kit for 1-3/4" Slipper Springs - 1-1/2" Tall Front
- Shop: Rear Hanger for 1-3/4" Slipper Spring
- Shop: Spring-Eye Bolt for Slipper Springs - 5-1/2" Long
- Q&A: Can I Use a 2" Hanger for a 1-3/4" Wide Leaf Spring
- Q&A: Hanger Kit to Install Leaf Spring on Trailer that Has Slipper Springs
- Video: Let’s Check Out the Front/Center/Rear Hanger for Double-Eye Springs
- Q&A: Can Leaf Springs with a Lower Weight Rating Be Used to Ease Ride of PWC Trailer
- Shop: Front Hanger for 1-7/8" Wide Slipper Springs - 3-7/8" Tall - 9/16" Bolt Hole
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 2-3/8" Tall - 9/16" Bolt Hole
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: How Much Do the Power Mountain Tallboy Off-Road Bottle Jacks Weigh?
- Q&A: Slipper Spring Hanger Positioning for 7,000 lb Tandem Axle
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: How to Determine Hanger Spacing for Tandem Axle Trailer Suspension with 26 Inch Springs
- Q&A: Replacement Bushing For Dexter 5-Leaf 10,000 Pound Axle Slipper Spring DX45QR
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Most Popular Wheel Bearings


Daniel B.
10/21/2025
just sent you an email. thanks!