Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
A stable rear hanger keeps the suspension working the way it should. This one is made for 1-3/4" wide “WI” series slipper springs and holds a 9/16" spring eye. It gives the slipper a firm pivot point so movement stays smooth and consistent mile after mile.
Getting the right alignment is easier when the hanger fits common configurations. This rear hanger is designed for single-, tandem-, or triple-axle suspension systems using 1-3/4" wide springs. Whether you’re refreshing one axle or building a full multi-axle setup, it lines up cleanly and seats the spring where it belongs.
A hanger only performs as well as its welds. Most users weld this part to the trailer frame with the top flush for maximum surface contact and strength, leaving the open side down. That solid connection helps prevent flexing or shifting, keeping the suspension geometry true under load.
With a 9/16" spring eye diameter, this hanger accepts standard suspension hardware built to handle real weight. It’s made to be a lasting mount that keeps the slipper spring secure through rough roads and repeated travel without loosening or deforming over time.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at the rear hanger for 1-3/4 inch wide slipper spring. This part includes one clip style rear hanger. It simply welds onto the frame of your trailer and holds the slipper end of a slipper spring that measures 1-3/4 of an inch wide. As you can see, it's made from a very durable steel construction. It's a weld on installation. A few measurements to go over with you real quick. Edge to edge, it's going to give us a measurement of about 2-7/16 of an inch, right in that area.
Measuring this direction, edge to edge, it's going to give us a measurement of 1 inch. Then top to bottom, it's going to have a hang down height or depth of about 1-3/16 to an inch and a quarter, right in that area. That's going to do it for today's look at the rear hanger for 1-3/4 inch wide slipper springs.
Ratings & Reviews
Oldswab
10/8/2023
Still working as advertised. Etrailer provides quality products that I trust. If it is important and has to work I buy from these folks.
Mike L.
10/25/2023
Rob L.
9/20/2021
Still working like a charm!
Do you have a question about this Trailer Suspension Part?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Brink
4/30/2025
It’s always a plus to have knowledgeable employees like etrailer who provide real answers to real questions. My product is still hanging strong. Haven’t had any issues since installing the slipper spring hanger.