Can I Use Adapter Sleeve In 3" Receiver Or 2-1/2" Receiver For Weigh Safe Pintle Hitch W/Scale?

Question

Question:

Can I use the 3" Weigh Safe Pintle Hitch on my Silverado 2500HD with a 2-1/2" receiver?

asked by: Don

0

Expert Reply:

Don, you won’t be able to use the 3" Weigh Safe hitches (# WS64WR or # WS89WR) in a 2-1/2" receiver - the shank is too large. If you actually have a 3" receiver, you could use a reducer sleeve like the etrailer # e33YR to step down to 2-1/2" and run the # WS97WR. But honestly, if you’ve got a 3" receiver, you’re better off sticking with the 3" version - the # WS64WR (6" drop) or # WS89WR (8" drop) - for a direct fit and maximum strength.

Do you know for sure if your Silverado came with the 2-1/2" or 3" receiver from the factory?

expert reply by: Andrew N

0

Answer 1

Hunter, the Weigh Safe Pintle Hitch 8" drop #WS97WR is rated to 22,000 lbs GTW, so your 20K rated trailer is within limits - just make sure your truck and receiver are rated high enough too. With that much weight, the built-in scale is a big…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

While we cannot confirm for sure what the "L" means on the 11033L, the "L" does not make a differences when coming to fitment of the hub. With that being said, the Tie Down Engineering 11033 hub has a 5 on 4-1/2" bolt pattern…

view full answer...

Answer 7

First I want to make sure you verify your channel mount for the Demco Trailer Coupler #DM14040-81 has a 21K or larger capacity as often times they are less like the Demco #DM15349-52 which often times people look at and think it is a channel mount…

view full answer...

Answer 8

We sure do Jerry and welcome back! To replace the Replacement Dexter Versa-Flex Torsion Arm Kit item #DX24FT. This replacement arm is designed for a 3,700-lb Dexter Versa-Flex axle. It's going to replace the entire arm assembly and rotor hub. It…

view full answer...

Can I Use Adapter Sleeve In 3" Receiver Or 2-1/2" Receiver For Weigh Safe Pintle Hitch W/Scale?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching