What Tow Dolly Does The Replacement Fender Assembly DM66MV Fit?

Question

Question:

I have a uhail tow dolly DEMCO . I need a right fender . Is this one the correct one , Part Number: DM66MV

asked by: Charles A

0

Expert Reply:

Hello Charles, thanks for reaching out. The Replacement Fender Assembly # DM66MV you were looking at is for the Demco Kar Kaddy X Tow Dolly part # DM9713093. I am not sure exactly which Demco tow dolly you have, but if it is the Kar Kaddy X, the # DM66MV will be exactly what you need.

If you have a different dolly just let me know and I am happy to look into it and see if we have the fender you need.

expert reply by: Jesse M

0

Demco Kar Kaddy X Tow Dolly
(click to enlarge)

Charles K.

10/2/2025

I have a u haul tow dolly ,it said that demco had made them. It may me an older older one, before surge brakes. Any help would be appreciated Chuck

Jesse M.

10/2/2025

@CharlesK So we would not have anything specifically for the Uhaul/Demco tow dolly, but we might have a generic fender that would work. For example, the Single Axle Fender # HP36VR is 9" wide, 32" long and 15" tall. It will work with most 14" and 15" wheels. If you can tell me the width, length and height of the current fender I am happy to look into it and see if we have anything to match.

Chuck

10/2/2025

@JesseM Thank you

Answer 1

The dimensions of Replacement Mud Flap for Demco Kar Kaddy Tow Dolly #DM56FR are 6-1/2" wide, 11-1/2" tall, and 3/16" thick. Just a side-note; this product is no longer oval/round at the bottom, it is now rectangular. I have attached a…

view full answer...

Answer 2

While I was unable to confirm the exact dimensions of the Norcold 1200LRIM, I think your current refrigerator to be 63-1/4 inches tall, 32-11/16 inches wide, and 24 inches deep. Please confirm this. The Everchill RV refrigerator with freezer drawer…

view full answer...

Answer 3

Demco doesn't have a big list out there of what tires work with the 3-Point Standard Wheel Tie-Down Strap #DM03528 (because that would be huge) but they do have a calculator that can be used to determine what size you need for your tire size. If…

view full answer...

Answer 4

The Replacement Fender Assembly for Demco Kar Kaddy Tow Dolly - Passenger Side #DM27FR does include the steel mounting plate underneath the fender assembly. I have linked a picture showing the mounting plate on the fender.

view full answer...

Answer 5

While the Replacement Fender Assembly for Demco Kar Kaddy 3 Tow Dolly #DM97FR and the Replacement Fender Assembly for Demco Kar Kaddy SS Tow Dolly #DR74FR are very similar they are not quite the same and you would not want to use the Replacement…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

What Tow Dolly Does The Replacement Fender Assembly DM66MV Fit?

Product Page this Question was Asked From

Continue Researching