Troubleshooting a Dexter Vault Hub that Has Popped Out Slightly
Updated 10/06/2025 | Published 09/29/2025
Products Featured in This Question
Question:
I have Dexter vault hubs on my vexus bass boat trailer. 3 of the 4 are flush with the end cap .. however one protrudes out slightly. Does this mean that something is wrong with the hub that 4 one that protrudes out. I provided photos to help articulate the issue. Thank you for any advise you can provide.
asked by: Steve J
(click to enlarge)
(click to enlarge)
Expert Reply:
Hey Steve, thanks for the pictures. That's normal. The Dexter vault hubs popping out slightly like that shows the system is pressurized. It'll pop out all the way if there's a leak or a problem.
I would check the other one though. It looks like it's leaking at the pilot hole but I don't know how long that grease has been there. I recommend wiping off the grease and seeing if it leaks out again. If it does you'll most likely want to replace that axles vault kit.
We have four options based on your axle capacity. I have listed them below:
2,500 lbs - 3,500 lbs - Dexter Vault Hybrid Lubrication Kit item # DX52UR
4,200 lbs - 5,200 lbs - Dexter Vault Hybrid Lubrication Kit item # DX23ER
6,000 lbs - Dexter Vault Hybrid Lubrication Kit item # DX83ER
7,000 lbs - Dexter Vault Hybrid Lubrication Kit item # DX73ER
How long have those vault hubs been installed?
Product Page this Question was Asked From
Dexter Trailer Axle Beam with Standard Spindles - 89" Long - 3,500 lbs
- Trailer Axles
- Leaf Spring Suspension
- Standard Grade
- No Hubs
- 3500 lbs
- Spindles Only
- 74 Inch Spring Center
- 89 Inch Hub Face
- No Drop or Lift
- Dexter
more information >
Continue Researching
- Search Results: bed extender
- Search Results: flat tow brake system
- Search Results: flat tow wiring harness
- Search Results: custom fit vehicle wiring
- Search Results: base plate for tow bar
- Search Results: patriot
- Search Results: tow ready flat tow wiring harness
- Shop: Curt 60x24 Hitch Cargo Carrier for 2" Hitches - 500 lbs Capacity - Matte Black
- Shop: OptiMate Panel Mount Power Socket with SAE to Auto Plug Kit - 12V
- Shop: Weigh Safe Ball Mount w/ Built-In Scale for 2" Hitches - 2" Drop - 10,000 lbs - Aluminum
- Shop: Trailer Hitch
- Shop: Dexter Vault Hybrid Lubrication System for 2,500-lb to 3,500-lb Trailer Buddy Axles
- Shop: Roadmaster Battery Ace Battery Disconnect w/ Key Fobs - Gas Only
- Shop: Caliber EdgeGlide XL Transition Plates for Enclosed Trailers - 72" Long -
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Wiring
- Shop: Suspension Enhancement
- Shop: Brake Controller
- Shop: Ladder Rack
- Q&A: Trailer Hitch And Wiring For A 2024 Toyota Tacoma
- Q&A: Will The Curt Class 3 Hitch C22ZV Fit A 2025 Toyota Tacoma
- Q&A: Option For Replacing Dexter Axle 89" HF 72.5 SC 2"x2" Square Axle
- Q&A: Replacement Kodiak Brake Kit for UFP DB-35 Brakes on Trailer
- Video: Installing the Dexter Hybrid Oil for The Vault Bearing Protectors
- Video: Setting Up Your Firestone Coil-Rite Rear Air Helper Springs - 2019 Ram 1500
- Q&A: Troubleshooting MaxxFan RV Roof Vent Lid that Doesn't Want to Open
- Q&A: Maxx Air Fan Lid Unable to Fully Open
- Q&A: What Causes MaxxAir Maxx Fan Lid Not to Open or Close
Steve J.
10/6/2025
Thank you so much for the input ... I will check them closer and monitor them moving forward .