Is the Clip Included with the Valterra Waste Valve for RV Black Water Tank T58?
Updated 08/05/2025 | Published 06/29/2025 >
Question:
Does the Valterra T58 include the hitch pin clip as shown on their website? The hitch pin is to prevent the waste valve from coming loose. Thanks
asked by: Carlso
Expert Reply:
Hello Carlso,
My apologies for the delay in getting an answer, our inventory is at our Salt Lake City warehouse, and I am in Wentzville, MO so it is a little difficult for me to go out and check.
I reached out to Valterra and they confirmed the all the # T58 come with the clip to hold into place.
What kind of camper is this going on? Any big adventures in the near future?
Product Page this Question was Asked From
Valterra Waste Valve for RV Black Water Tank - Twist On - 3" Bayonet Hooks to 3" Lug
- RV Waste Valves
- Straight Valve
- Single Waste Valve
- 3 Inch Valve Body
- Manual
- 3 Inch Bayonet
- Stationary Valve
- Valterra
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: How to Gain Additional Clearance on Brinkley Model G 3970 With Gen-Y Gooseneck Pin Box
- Article: Thank you!
- Q&A: What are Bag Dimensions of Andersen Camper Leveler part # AN68VR
- Q&A: Internal and External Dimensions of MORryde Sliding Tray for RV Cargo Compartment # MR77FR
- Q&A: Availability of 7-Way Trailer Connector With 8 Gauge Wire for Power and Ground
- Q&A: Can Extension Rods in Valterra Waste Valve Extension Rod Kit be Attached to Each Other
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: Recommended Convection Microwave for a 20-1/2 Inch Wide Cutout
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Maintenance Schedule
- Article: Trailer Lighting Requirements
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub




Carlos
7/12/2025
Thanks Kate for the reply! It's a back up valve for a "just in case" event where my current glued in valve leaks! Outback 250RS. Heading up next week to the Eastern Sierras for some trout fishing!!