Does Replacement Touch Panel Assembly for Lippert OneControl # LC75UD Require Programming

Question

Question:

If i buy lc75ud control panel will it have to be programmed or just plug in it work as should thanks

asked by: Jeff H

0

Expert Reply:

Hey Jeff, the Replacement Touch Panel Assembly for Lippert OneControl # LC75UD that you referenced does not require any pairing or programming. You'd just need to plug it in and it's ready to be used.

expert reply by: Jameson C

0

Answer 1

For an upgrade over the Drive stereo you have now the Jensen Stereo part #JWM60A that you referenced is our best choice. It essentially has all of the same features as the Drive while being a bit more reliable. It's designed for RV in-wall…

view full answer...

Answer 2

Hello William. We do have the Replacement CAN Bus Data Cable for Lippert Ground Control or OneControl Leveling System #LC45ED. This cable is 20' long and will replace the cable that connects to your ground control leveling system. This is…

view full answer...

Answer 3

It sounds like your RV manufacturer may have left off some parts for the Lippert OneControl ConnectAnywhere Cellular Upgrade Kit #LC55UD. This would not be the first time I have seen this happen as these are built by people and things do get missed.…

view full answer...

Answer 4

You will need the Replacement CAN Bus Data Cable #LC45ED for the Touch Screen #LC83VR on your 2020 Forest River Vengance Rogue travel trailer toy hauler. This 20' cable will replace your current cable that connects into your Ground Control…

view full answer...

Answer 5

Hey Skyler! The #LC85ED (803279) is the correct replacement for your 346005. I just confirmed this with Lippert. They weren't able to tell me if it had an antenna or not but it is the direct/only replacement so I assume it does or at least…

view full answer...

Answer 6

The 5 inch and 7 inch screens are interchangeable. If you want a 5 inch screen you'd want the part #LC83VR or if you want a 7 inch screen part #LC75UD.

view full answer...

Answer 7

Hey Vince; there are two small screws at the bottom of the #LC75UD which connect it to the bracket. Once you remove these two small screws you will lift it up and off of the tabs on the bracket. See the attached photos.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Does Replacement Touch Panel Assembly for Lippert OneControl # LC75UD Require Programming

Product Page this Question was Asked From

Continue Researching