How to Remove/Install Replacement Touch Panel Assembly for Lippert OneControl

Updated 07/20/2025 | Published 07/15/2025

Question:

How is this panel actually installed, how do I remove the original? Simply pull the panel straight away from the wall? Pry a corner? Use a trim pry tool or similar? There are no apparent screws or fasteners. 2024 GD Momentum 395 MS Thanks!!!

asked by: Vince R

Expert Reply:

Hey Vince; there are two small screws at the bottom of the # LC75UD which connect it to the bracket. Once you remove these two small screws you will lift it up and off of the tabs on the bracket. See the attached photos.

expert reply by: Robin H

Replacement Touch Panel
(click to enlarge)

Vince

7/20/2025

Thanks for the reply Robin but, unfortunately, the Lippert OneControl Panel is not a # LC75UD.

Robin H.

7/20/2025

@Vince there are a few different versions of the panel so if you can email me a picture I'll take a look at what you have. Sometimes they tie in other systems as well so it may be an OEM only touch panel but I can ask Lippert about it or look it up in their documentation.