Do I Need to Cut or Trim the Bumper Fascia on My 2024 Audi Q5 to Install the Curt Hitch Receiver?

Question

Question:

Hi, do you know if this hitch require cutting rear bumper fascia on 2024 Audi Q5? Thank you.

asked by: Mike

0

Expert Reply:

Hello Mike,

Yes, there will be minor trimming on your 2024 Audi Q5. If you watch the install video I attached the CURT # C98JR hitch receiver typically installs on the 2020 Audi Q5 without any fascia trimming, the 2024 model often requires minor trimming due to changes in the rear fascia design starting in 2021. These updates, especially on trims with sport styling or a lower rear valance, mean the receiver tube may not clear the fascia without a small notch cut into the lower center section. The trim is minimal and generally not visible once the hitch is installed. I would like to point out that it does have a 10 out of 10 for difficulty, that is because it takes quite a bit of time to get the car taken apart to put the hitch on.

What are you looking to use the hitch for? Do you need any wiring to go with the hitch?

expert reply by: Kate F

0

Curt Hitch Installed on 2020 Audi Q5
(click to enlarge)

Mike

4/12/2025

Thanks a lot Kate. I'll be using the hitch only for bike rack - no wiring is needed.

Kate F.

4/14/2025

@Mike Got it Mike! This hitch will be great for a bike rack. Happy riding =)

Answer 1

Yes, it does William. The ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit item #119250KIT does indeed come with a power module. This is a universal harness that will allow you to add a 4-way…

view full answer...

Answer 2

Hi Shawn; for your 2025 Audi Q5 PHEV I recommend the Curt Trailer Hitch Receiver #C98JR. This is a Class III hitch with a 2" receiver and a bolt-on installation. It has a 750 lb max tongue weight which will be more than enough to handle your…

view full answer...

Answer 3

Hey Laura! The etrailer Hitch item #e94CR is the correct one for the 2023 Audi Q5 PHEV. It fits both models of your vehicle which is why it says excluding Plug-In Hybrid and Plug-In Hybrid. Confusing, I know we get this question often. If you are…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Yes, it does! The etrailer Hitch item #e94CR has been confirmed to fit all models of the 2024 Audi Q5 including the plug-in hybrid model. This hitch is custom fit and bolts to your Audi with included hardware. It is a class III hitch with a 2"…

view full answer...

Answer 6

I would be happy to make a recommendation for a trailer hitch for your 2021 Audi Q5. Between the Curt Trailer Hitch Receiver #C13331 and Draw-Tite Max-Frame Trailer Hitch Receiver #76183 I recommend the Curt #C13331 due to it allowing the rear bumper…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 10

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 11

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Do I Need to Cut or Trim the Bumper Fascia on My 2024 Audi Q5 to Install the Curt Hitch Receiver?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching