Is there a Bus Bar for the Pollak 7-Circuit-Breaker Junction Box PK52249?
Updated 10/30/2025 | Published 02/25/2025
Products Featured in This Question
Question:
Hello- Id like to replace the trailer frame mounted circuit breakers on my 2022 Micro Minnie FLX 2108DS and enclose them in this junction box. Does Pollack make a bus bar that can be used to connect all the circuit breakers on a common negative terminal? Im not sure if typical bus bars will line up with the spacing of the circuit breakers in this box. Thanks
asked by: George R
Expert Reply:
Hey George! Sorry but there is not a bus bar designed for the Pollak 7-Circuit-Breaker Junction Box item # PK52249. It's only designed to have the circuit breakers mounted inside it. It's been designed for studded circuit breakers like item # PK54-120, item # PK54-130, and item # PK54-140.
Product Page this Question was Asked From
Pollak 7-Circuit-Breaker Junction Box
- Accessories and Parts
- Trailer Wiring
- Junction Box
- Pollak
more information >
Continue Researching
- Search Results: bauer lock cylinder
- Video: An In-Depth Look at the Replacement Flush Mount Rubber Grommet
- Video: An In-Depth Look at the Rubber Grommet for 3/4" Round Trailer Lights
- Shop: Pollak 7-Circuit-Breaker Junction Box
- Shop: Rubber Grommet for 3/4" Round Trailer Lights - Recessed Mount - Open Back
- Shop: Rubber Grommet for 3/4" Round Trailer Lights - Recessed Mount - Open Back
- Shop: Replacement Flush Mount Rubber Grommet - 3/4" Diameter - Qty 1
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Can a DC to DC Charger Be Mounted in a Trailer's Battery Box to Keep the Trailer Battery Charged?
- Q&A: How Many Amps Do The Largest Velit AC Units Draw?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Looking For Replacement 7-Way Plug With Double Prong Design
- Q&A: How Do Wires Connect to TowSmart ProClass 7-Blade Trailer Connector w/ Wire Tester
- Q&A: Looking for Replacement Distribution Panel for IOTA IDP-30
- Q&A: How do I Trickle Charge a Battery on my Trailer
- Q&A: Can Redarc In-Vehicle BCDC Trailer Battery Charger Charge Two 100 Amp-Hour Batteries
- Article: Trailer Lights Not Working After Winter? Test Truck or Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing
Jerred H.
10/30/2025
Hey George, did you end up using the Pollak junction box with those studded circuit breakers? Knowing how your setup turned out could help others planning a similar wiring project.