Does Kodiak Disc Brake Kit KOD77FR Come with Brake Pads

Question

Question:

This kit comes with the pads? If no, pls. send link to the pads for this model. Thanks

asked by: Carlos K

0

Expert Reply:

Hey Carlos, yes the Kodiak Disc Brakes part # KOD77FR do come with brake pads. You would not need to add them separately. Are you putting disc brakes on a trailer that had drum brakes?

expert reply by: Jameson C

0

Jameson C.

10/30/2025

Hey Carlos, how did things go with the Kodiak disc brakes and pads? Your update could make it easier for the next person switching from drum to disc brakes.

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 5

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 6

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 7

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hi Calvin! All of the pre-greased hubs/drums, like the Terran Industries Trailer Hub and Drum Assembly - 3.5K Axles - 10" Diameter - 5 on 4-1/2 #TX68VJ, come with bearings made overseas and are all basically the same quality. At least that I…

view full answer...

Answer 10

Hey Frank! This is a newer product, so there aren't many long-term owner reviews available yet. That said, we have done extensive testing on the Benton MoveHitch #B86VR. A strain gauge was used to measure the forces the carrier experiences during…

view full answer...

Does Kodiak Disc Brake Kit KOD77FR Come with Brake Pads

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching