What Type of Cable is MaxxFan Communication Cable MA59PR

Question

Question:

What type cable is this. I want to by a tester to check continuity. This is the 20’ control cable for a max air fan

asked by: Mark R

0

Expert Reply:

Hey Mark, the MaxxFan communication cable part # MA59PR is an RJ45 data cable.

expert reply by: Jameson C

0

Jameson C.

11/17/2025

Hey Mark, did the RJ45 tester work for checking continuity on your MaxxFan control cable? Knowing how it turned out could help others trying to test the same setup.

Answer 1

I wasn't able to reference this part number but we do carry a few wall mount switches for MaxxAir Vent Fans, the part #MA59FR and part #MA00A03550K. If yours look like either of these two options then they will work great for you but they are the…

view full answer...

Answer 2

There is not an easy way to verify the tongue weight of a fifth wheel trailer if you do not already have the trailer. The best way to find the tongue weight of your fifth wheel trailer is to use a commercial scale like those at truck stops or at…

view full answer...

Answer 3

Even when stored in the somewhat controlled environment of a garage, tires are still subject to dry rot and flat spotting. Even if the tire tread has plenty of depth left and you can't see any cracking with the naked eye, the generally accepted…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 6

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Answer 7

Hey Tim welcome back! Your ARH15AACBL2 GE AC unit has the old 410a refrigerant in it so the GE Appliances item #GE64FR you were looking at isn't going to work as a replacement. The EPA mandated R32 refrigerant has been used in all new AC's…

view full answer...

Answer 8

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 9

Hey Todd, the better option is definitely the Curt Flex Air part #LC328492 over the Airride #LC158778. The Flex Air has the same vertical air bag cushioning as the Air ride but it also has horizontal cushioning in the pin box mounting plate to…

view full answer...

Answer 10

Hey Mike. I have a solution for you but what your asking isn't going to work. The Lippert 1716 5th Wheel Pin Box item #LC1324791 you referenced fits a 1716 bolt pattern, which is not compatible with your trailer's 1621 pin box. The closest…

view full answer...

Answer 11

Because it's lighter, less expensive, has fewer moving parts and is mechanically less complicated I'd recommend going with the Gen-Y #325-GH-8040 shock absorbing pin box versus a Trailair Flex Air like part #LC328492. The Trailair features a…

view full answer...

Answer 12

Hey Jim, When it comes to chucking I'd have to say that the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is going to be the better option over the Lippert/Curt Flex Air Pin Box #LC369535. The Gen-Y has a rubber torsion spring design…

view full answer...

What Type of Cable is MaxxFan Communication Cable MA59PR

Product Page this Question was Asked From

Continue Researching