Replacement for MTP 5103 Seal
Updated 11/17/2025 | Published 11/29/2024
Products Featured in This Question
Question:
Looking for a seal. MTP 5103
asked by: Oscar O
(click to enlarge)
Expert Reply:
Hi Oscar; I can see how you ended up here since a search for the MTP 5103 pulls up our CE Smith Grease Seals # CE16305A. However, I don't see anything that corresponds with the MTP 5103. I also wasn't able to find measurements using that part number so I can't confirm these are the right replacement.
The best thing to do is take a digital caliper # PTW80157 and measure the inside and outside diameter of your current seal. If your inner diameter is 1.00" and outer diameter is 1.78 " the # CE16305A will fit. If you have different measurements please add them in the comments below and I will see if we have a replacement that matches.
Product Page this Question was Asked From
CE Smith Grease Seals - 10174VB - Single Lip - Qty 2
- Trailer Bearings Races Seals Caps
- Seals
- Grease Seals - Single Lip
- 1.00 Inch I.D.
- 1.78 Inch O.D.
- CE Smith
more information >
Continue Researching
- Search Results: mtp 5103 seal
- Shop: CE Smith Grease Seals - 10174VB - Single Lip - Qty 2
- Q&A: Replacement Seals for Hubs on Dexter D35 Axle
- Q&A: Which Hubs Fit the # TRU37FR Spindle
- Q&A: Bearing Buddy to Fit Ranger Tandem Trailer with Hub Bore Diameter 2.296 in
- Q&A: Selecting Bearing Buddy for Ranger Trail Boat Trailer
- Q&A: Determining Correct Grease Seal and Axle Capacity on Vintage Trailer
- Q&A: Does The Insta Holding Tank Patch Kit # SR48RR Adhere To Polyethylene
- Q&A: Help Picking Out Replacement Hub for TDE 11033
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Most Popular Wheel Bearings
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Install E-Track in 3 Easy Steps
Robin H.
11/17/2025
Hi Oscar, did you get a chance to measure your old seal with the digital caliper? Once you had those inner and outer diameters, were you able to confirm if the CE Smith grease seals were the right fit? Your update could make it easier for the next person trying to match that MTP 5103 part.