Will The Swift Hitch Digital Wireless Hitch Alignment Camera Hook Up To Your Phone With Bluetooth

Question

Question:

Can you hook it up to your phone Bluetooth

asked by: George

0

Expert Reply:

Hello George.

The Swift Hitch Digital Wireless Hitch Alignment Camera and Monitor - Night Vision - 8-Hr Camera Battery # SH02Digital does not hook up with your phone with Bluetooth. The camera only works with the included monitor. By doing so it eliminates interference from devices that use Bluetooth of Wi-Fi.

expert reply by: Kate F

0

Gstets

11/7/2024

So you can only see through the small two and a half inch screen can't plug it into anything else

Kate F.

11/7/2024

@Gstets Yes, that is correct. The wireless camera system uses a closed bluetooth system so they can only communicate with each other. This way other devices cannot cause interference. The lack of interference is a nice touch, but I get why you would want to use a bigger screen.

Kate F.

11/19/2024

@Gstets If you want something with a bigger screen, we do have the Drive Wireless RV Backup Camera System w/ Night Vision - Rear Mount - 7" Screen # 324-000002. The view will be a lot more visible on a 7" screen.

Helpful Links

tv-demo-way-interglobal-rv-electronics-324-000002.aspx

Answer 1

There isn't a larger monitor specifically for backup camera #SH02Digital but you can run the video feed out to a different monitor if you wanted to. I have included a link to a video review of this backup camera system for you.

view full answer...

Answer 2

Hello. The etrailer Electric Trailer Jacks #e55ZV and #e23ZV do have a manual backup option. You just remove the rubber cap on top of the housing and you can use the included manual crank to raise/lower the jack. Take a look at the picture below and…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 10

Hello Kevin, Thanks for writing in. The main difference between the Power Watchdog Surge Protectors #HU67FR and #HU42VR comes down to the monitoring capability, housing design, and surge protection rating. The #HU67FR is the newer Generation 2 model.…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Will The Swift Hitch Digital Wireless Hitch Alignment Camera Hook Up To Your Phone With Bluetooth

Product Page this Question was Asked From

Continue Researching