Brake Controller And 7-Way Connector For 2013 Toyota Sienna  

To route the trailer wiring connector outside on your 2011 Toyota Sienna you will need to find a grommet in the rear of the vehicle. I attached a photo showing a grommet that can be used in the cargo area of the 2011 Sienna under the carpeting. We…

We can get your 2016 Toyota Sienna XLE set up with what you need for the hitch, wiring, and brake controller. It can definitely be a bit overwhelming so it's a good idea just to verify, and you made a really nice choice with the Draw-Tite…

The Rhino-Rack Artificial Rain Gutters #739A are a universal fit since you'd be drilling through the wall of the trailer and bolting them in place. The only issue you might have is just with the bolt length. If the wall is too thick then…

The best option we have for a roof rack that would have crossbars 10-12 inches above the roof of the trailer would be with the Rack Em Trailer Ladder Rack part #RA-28 which was designed for enclosed trailers but has the taller towers/feet. There…

I do have an option for you but roof rails won't work very well on a teardrop trailer, even if you were able to get the rails to conform, it's likely the accessories would bind due to the steep angles. Instead, you will need to use artificial…

I have some great roof rack options for a Little Guy Silver Shadow Teardrop Trailer. I recommend the Rhino-Rack Aero Bar Roof Rack part #Y02-480B as it's a complete systems with adjustable tracks so you can accommodate a wide variety of loads, it…

Any time you remove a trailer wheel you have to torque the lug nuts a few times so that they don't back themselves off like what you are experiencing. It is important to re-torque the lug nuts after 10 miles, 25 miles, 50 miles and then monthly…

When we installed the Tekonsha Prodigy P2 brake controller #90885 on a 2012 Toyota Tacoma we found the best mounting location to be on the dash at the left bottom near the trunk latch and the fuse box. See the image and the video I have attached…

It's not by much but it looks like the Draw Tite Hitch part #36513 tucks a little bit closer to the rear bumper than the Curt part #C12065. The difference is right around an inch. Another advantage the Draw Tite has is that it doesn't require…

You can trim the appearance panel underneath your 2013 Toyota Sienna and reinstall it when using Draw-Tite trailer hitch #75237. If you choose not to you can just leave it off. I have linked the instructions that mention where to trim. You would not…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…