P2 or P3 Brake Controller for 2006 Phaeton Motorhome

Question

Question:

I need a brake controller for my 2006 Phaeton motorhome. I'm getting a flatbed trailer with electric brakes. P3 or P2

asked by: Steven

0

Expert Reply:

Hey Steven, I would recommend going with the P3 part # 90195 over the P2 # 90885 for your application. I prefer the full words on the display of the P3 instead of the codes that have to be interpreted.

expert reply by: Jameson C

0

Steven

10/15/2024

Thank you Any idea of what wiring adapter I need for it to my coach

Reply

Jameson C.

10/15/2024

@Steven Under your driver side dash there are 4 wires that have butt connectors on them. They are labeled by function. To install a brake controller like the Tekonsha Prodigy P3 # 90195 that you referenced connect the following wires from the pigtail that comes with the P3 to the following functions: Black - 12V Power Supply White - Ground Blue - Brake Controller Output Red - Stop Light Switch

Reply

Answer 1

The Tekonsha PowerTrac brake controller #39523 is a time delay brake controller. The other type of controller is a proportional controller. A time delay controller is so named because there is a delay between the time that you initially apply the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 6

Hi Mike! Do you want a completely hidden hitch or one where only the receiver is visible? The Curt #C64NR you looked at has a concealed cross tube so you will only see the receiver hanging down at the rear. The Hidden Hitch by Draw-Tite #DT76GR will…

view full answer...

Answer 7

Hello, and thanks for getting in touch. The etrailer Electric Trailer Jacks #e55ZV and #e23ZV will hold up just fine in cold weather. The housing is designed to be water/weather resistant. It even has a manual backup option if you were to lose power…

view full answer...

Answer 8

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 9

Hello Rocky, thanks for reaching out. If your new leaf springs do not have as much of an arch as the old springs they are definitely not going to help your situation if your tires are already rubbing on the fenders. What we would usually do here is…

view full answer...

Answer 10

To power the Solera Smart Arm 12V Power RV Awning #LC517486 you simply will connect your white power wire with the white wire from the switch and run that to the positive terminal of the battery inline with the supplied 15amp fuse. From here, connect…

view full answer...

Answer 11

Hey Ron, good to hear from you! How long are your current U-Bolts? The U-Bolt Kit #APUBR-8 could potentially work as it has 7" long U-Bolts, but it really boils down to what you currently have. For something longer we have the MORryde U-Bolt Kit…

view full answer...

Answer 12

Hey James, you can go with a 4k axle leaf spring like the part #e22YR in place of what you have now while it has a slightly higher weight capacity it's not enough that it would create a harsh ride quality. This is a 26 inch long spring though so…

view full answer...

P2 or P3 Brake Controller for 2006 Phaeton Motorhome

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching