Parts Needed to Install Replacement Leg for etrailer and Ram Hydraulic Jack Setup on Dump Trailer

Updated 12/22/2025 | Published 10/13/2024

Products Featured in This Question

Replacement Leg for etrailer and Ram Hydraulic Jack Setup - Square Tube - Weld On - 12K lbs - Qty 1

(14)

$399.08

Dexter Single Hydraulic Jack System w/ Double Acting Pump - 20" Lift - 10,000 lbs

(5)

$1515.53

Replacement Power Unit for etrailer and Ram Hydraulic Trailer Jacks and Scissor Hoist Systems

(23)

$521.98

Question:

I was hoping to get all of the accoutrements that I would need to install this on my dump trailer. I currently have a hand crank Jack and I am ready to upgrade to this, but I don’t know what all I will need besides my welder. Please help this ignorant veteran.

asked by: Sean B

Expert Reply:

Hi Sean; we only sell replacement parts for this setup at this time so we do not have every part you need. We have the leg # e93VV and the Replacement Power Unit for etrailer and Ram Hydraulic Trailer Jacks and Scissor Hoist Systems # e43VV.

The fittings and lines are something you will have to acquire elsewhere. I went ahead and attached a diagram below showing the single jack installation. The full instructions are also attached further down on this page which cover dual jack applications and what to do if you're welding.

I do have an option for a complete system which is the Dexter Single Hydraulic Jack System w/ Double Acting Pump # DX62CR. If you want to add a hydraulic jack this is the way to go.

expert reply by: Robin H

Single Hydraulic Jack Application
(click to enlarge)

Robin H.

12/22/2025

Hey Sean, how did things go with adding the hydraulic jack system to your dump trailer? Did the Dexter setup give you everything you needed for the upgrade? Your update could make it easier for the next person planning a similar change.