Video Transcript for Review of etrailer Replacement Jack Leg - e93VV

Hello, neighbors. Steven here with etrailer.com. Today we're looking together at a Replacement Leg for your etrailer and Ram Hydraulic Jack setups. It's a square two weld-on application, rated at 12,000 pounds. So folks, with this you can replace one Ram square two leg from your etrailer or Ram hydraulic jack setup. Now that hydraulic pump and power unit, item number E43VV, is sold separately.

Now this does work with units offering up to 3,200 PSI extension, and 1500 PSI retraction pressures. Again, it's a welded application. It's gonna provide stability with large, pivoting footprints. Foot plates, rather. So I've got these wedges in here, just to keep it from falling off the table.

But as you can see, this could pivot really easily as needed. Got a lot of travel there with it. And I'm gonna go ahead and stick these wedges back in here for my safety. Okay, and then obviously at the top here, you've got a hole here. It's kinda hard to see because it's black.

You got a hole here, and you got your attachment points and everything over here on this side. So the screws travel for this is 24 and a quarter inches of travel. The bracket height is 34 and seven eighth inches when it's retracted. So you need to make sure when you're welding this on at the bracket height, you get it correct. Overall, if you had this fully extended, it would be 59 inches extended.

Right now with it retracted from the bottom of the tube, so not the ground, but the bottom of the tube all the way up here to the top, it's 34 and seven eighth inches retracted. Lift capacity, 12,000 pounds. It says it right here on the manufacturer sticker as well. The support capacity is 15,000 pounds. The foot pad is a 10 inch by 10 inch pad, so it's gonna give you a great stability on the terrain, soft ground, those kind of things, so you don't have to worry about it sinking down like other jacks. Well folks, it's got a nice black powder coat finish all around it. Very nice jack. And as far as the tubing here, I got four and a half by four and a half square on the tubing itself. And that's gonna wrap it up for our quick look at this Replacement Leg for your etrailer and Ram Hydraulic Jack setups. I'm Steven. Thanks for watching, and as always, stay safe while you're towing.