Will MaxxFan RV Roof Vent Fan Remember Speed Setting if Power is Cut

Question

Question:

My bathroom fan uses a switch to turn it off and on. If I turn this fan on to say speed 3 and then use the switch to turn it off will it remember it’s setting and come back on when I turn the switch back on?

asked by: Tim

0

Expert Reply:

Hey Tim, if you cut power to the MaxxFan part # MA00-06401K it will lose it's most recent fan speed setting so instead a better option would be to go with a fan that has a remote you could use to pick the speed like the MaxxFan part # MA00-07500K.

expert reply by: Jameson C

0

Tim

9/30/2024

Do I just leave the switch always on then and only use the remote? Can the remote be mounted on wall or do they make a wireless wall switch of sorts?

Jameson C.

9/30/2024

@Tim You'd leave switch on all the time and then use remote to control it. The remote can be wall mounted as well as it comes with a wall mount to hold it.

Tim

9/30/2024

@JamesonC is there a cheaper option that uses a remote but is maybe only 4 or 6 speed? That 10speed is considerably more than the one I was looking at

Jameson C.

9/30/2024

@Tim # MA00-07000K and # MA00-04500K have remotes too and look a bit less expensive.

Answer 1

Welcome back Anthony! The Curt parts you were looking at are compatible with your Silverado and each other but I recommend the B&W Companion OEM 5th Wheel Hitch w/ Slider item #BWRVK3775. The B&W Companion w/ Slider item #BWRVK3775 is one of…

view full answer...

Answer 2

Hey Kevin. The Replacement Door item #DMC58FR is designed to fit the Dometic RV Water Heater item #DMC74FR, which has vents built into the unit itself. This 6-gallon water heater would be a great option to replace a Suburban SW6DEL heater but the…

view full answer...

Answer 3

It sure can Larry. The Mach-C Everest Variable Speed RV Air Conditioner System item #CM35MR includes an air distribution box that can be used for a top down set up. There's a baffle built into the air distribution box that can be removed to push…

view full answer...

Answer 4

Hey Paul! The PullRite SuperGlide #PUL43RR (2714) and #PUL73RR (2914) do weigh the same. The main difference is the capacity, which is going to come from the base of the 5th wheel hitch. Since your 2027 Keystone Cougar 316RLS has a GVWR of 12,900 lbs…

view full answer...

Answer 5

Welcome back Chris. The original MaxxFan 5100k fans couldn't handle the extra voltage from Lithium batteries and the boards would burn out. A green light would come on and beep after the fan runs for only a few seconds, which sounds like exactly…

view full answer...

Answer 6

Hi David, thanks for reaching out. Based on the information you provided, you are on the right track. The Replacement Lippert Control Panel with Amp Connector for 4-Point Leveling System #LC175225 is the correct replacement for your LCI 4-point…

view full answer...

Answer 7

Hi Bernd, I went out to our warehouse to measure the channel nut for this kit for you. The dimensions of the channel nut for the Replacement M6 Channel Nut and Screw Set for Rhino-Rack Pioneer 6 Platform part #RR62NE are as follows: 18.0 mm long,…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Will MaxxFan RV Roof Vent Fan Remember Speed Setting if Power is Cut

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching