Maximum Weight Capacities and Mounting Information for the Titan 6-Hole Adjustable Channel Bracket

Question

Question:

what are the max load capacities of this brackets tongue and gross towing? the description says the channel opening is 3.5inch wide, does it come with spacers because most tongue channels are 3inch wide? what are the mounting bolt diameters? what are the distances between these bolts? I need to know if it fits the conventional bolt tongue patterns of most trailers. Can you guys do an information video on this titan mounts to the togue. I would like to see how it looks on a trailer and with all the possible attachments. Since most non commercial trailer tongues are 3inch wide and this bracket is 3.5inch wide, I would like to see ideas on how to make this product look good with having to use unsightly washers to fill in the half inch gap between the channel. thanks!

asked by: Ray

0

Expert Reply:

The Titan 6-Hole Adjustable Channel Bracket, # T4865900, has a tongue weight capacity of 2,000 pounds and a 20,000 pound maximum gross towing capacity.

I spoke with my contact at Titan and the channel width of 3-1/2 inches is the measurement of the bracket, outside to outside. The steel brackets are approximately 1/4 inch thick which makes the opening of the bracket at 3 inches.

This channel bracket is constructed to work with most trailers and uses two sizes of mounting bolts, 5/8 inch and 1/2 inch. I am attaching a photo to show you the location of the mounting holes.

All of our installation videos are produced when our local customers come into our shop to have our products installed on their vehicle. If a customer schedules an installation for the Channel Bracket, #T4865990, on their trailer, our video team will be on it!

expert reply by: Leah S

0

click to enlarge

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 3

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 4

The appropriate torque spec for any application will vary depending on the construction of the wheel as well as on the stud size. I suggest checking the wheels you're using to see if their manufacturer has a suggested torque rating. Steel trailer…

view full answer...

Answer 5

We sure do Jerry and welcome back! To replace the Replacement Dexter Versa-Flex Torsion Arm Kit item #DX24FT. This replacement arm is designed for a 3,700-lb Dexter Versa-Flex axle. It's going to replace the entire arm assembly and rotor hub. It…

view full answer...

Answer 6

Hey Donna, yes the Replacement Grease Cap for Dexter/Tie Down Engineering Vortex Trailer Hubs #DE69NR that you referenced does work as a replacement for your Dexter 21-261 cap. How do you like the Vortex trailer hubs?

view full answer...

Answer 7

Hello James, thanks for reaching out. Both the kits you mentioned, the Hydrastar #HYD22FR and #HYD42FR are complete conversion kits for standard 3,500 lb axles. The difference is the calipers included with each kit. The #HYD22FR has stainless steel…

view full answer...

Maximum Weight Capacities and Mounting Information for the Titan 6-Hole Adjustable Channel Bracket

Product Page this Question was Asked From

Continue Researching