Will Camco Insulator for RV Roof Vents Fit 13-1/2" x 13-1/2" Opening

Question

Question:

The inside of my roof vents measure 13 1/2× 13 1/2, a little smaller than 14 x14 .Will these insulators fit up in there?

asked by: Greg P

0

Expert Reply:

Hello Greg; the Camco Insulator for RV Roof Vents # CAM45195 will fit your roof vent opening. These are made of foam so with a difference of 1/2" you won't have a problem compressing it down slightly to fit the space.

expert reply by: Robin H

0

Gregpope

9/25/2024

Thank you for your reply.

Answer 1

Did you check the fuse on the back of the stereo? If it's not that the internal amp has damaged itself and would require replacing the stereo with something like the Jensen #JWM60A that you referenced.

view full answer...

Answer 2

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 5

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

The RV Propane Gas Detector part #RS64FR is what I recommend using to replace the the Atwood RV Propane Gas Detector part 31013 (Discontinued). The mounting plate for this new detector will cover up any holes you had for the previous so it will be a…

view full answer...

Answer 8

Hey Mark, welcome to the fifth wheel community! I'd be more than happy to help you. So a fifth wheel hitch will sit lower than the top of the truck bed rails so you wouldn't have to remove the head of the hitch to close the cover BUT the…

view full answer...

Answer 9

Hey Gene, welcome back! The correct tie-downs are the TorkLift Talon item #TL45SV, you were looking at. This a set of front and rear tie-downs. The rear ones will attach directly to your 2025 Ford F-450's TorkLift SuperHitch Magnum hitch item…

view full answer...

Answer 10

Hey Mark, the only real downside to an offset ball like the Gen-Y part #GY43XR is going to be that it costs more typically and it would take up more room when stored compared to a non-offset ball like the #C38CR. The handling and weight carrying…

view full answer...

Answer 11

Hi Hilario, congrats on the new truck! ^___^ If this were my truck and I was installing a retractable cover on it (which I actually did with my Silverado), I would go with the manual RetraxPRO XR Hard Tonneau Cover - Retractable - Aluminum - Matte…

view full answer...

Answer 12

Hey Travis, since your Grand Design Reflection 100 Series 28RL has a Lippert 1621 style pin box on it currently the correct Gen-Y fifth wheel to gooseneck adapter that is cushioned you'd need is the Gen-Y part #GY38FR. What gooseneck hitch do you…

view full answer...

Will Camco Insulator for RV Roof Vents Fit 13-1/2" x 13-1/2" Opening

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching