Screen Door Will Not Close After Installing Lippert SolidStep - Is There A Solution?
Updated 07/07/2024 | Published 06/23/2024
Question:
I just installed the 3 step Step system onto my RV. The issue I have is the screen door does not close. Is there something I did wrong or do you have a solution? Thank you
asked by: Rodney Z
Expert Reply:
Hello Rodney, thanks for reaching out. You did not necessarily do anything wrong when installing your step. It is not entirely uncommon for the Lippert SolidStep RV Steps like part # LC791572 to cause interference with the screen door.
The recommended solution for this is to trim the bottom of the screen door frame. To do this, with the steps down, take a piece of tape and place one on each side, down on the threshold at the edge of the step bracket. From here you'll need to raise the steps up inside the door frame, separate the screen door from the outer door, close your screen door, and mark the bottom edge of the screen door frame at the edge of the tape. This'll be the width you need to cut. Doing this will allow the screen door to close, the entry door may still be tight, but it will be close.
Product Page this Question was Asked From
Lippert SolidStep RV Steps for 25" to 28-7/8" Wide Doorways - 3 Steps
- RV Steps
- Towable Camper
- Fold-Down Step
- 20 Inch Wide Step
- 22-1/2 Inch Wide
- 3 Steps
- 8 Inch Drop/Rise
- 28 Inch Entry
- 29 Inch Entry
- 30 Inch Entry
- 31 Inch Entry
- 32 Inch Entry
- 34 Inch Entry
- 36 Inch Entry
- Aluminum
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Search Results: rv door catch
- Shop: Convert-A-Ball Ball Mount for 2" Hitches - 10-3/4" Rise, 12" Drop - 7,000 lbs
- Shop: BulletProof Hitches 2-Ball Mount for 2" Hitch - 11-1/4" Drop, 11-1/2" Rise - 30K
- Video: Convert-A-Ball Ball Mount for 2" Hitches Feature Review
- Video: All About the Convert-A-Ball Ball Mount for 2" Hitches
- Video: A Closer Look at the Mdemo Gopower Solar Charging System
- Search Results: lippert rv steps
- Shop: MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways - 3 Steps
- Shop: MORryde StepAbove RV Steps for 27-3/4" to 30-1/4" Wide Doorways - 3 Steps
- Shop: MORryde StepAbove RV Steps for 27-3/4" to 30-1/4" Wide Doorways - 3 Steps
- Shop: Lippert SolidStep RV Steps for 29" to 36" Wide Doorways - 3 Steps
- Shop: Go Power PWM Solar Charge Controller with Bluetooth - LCD Display - Single Bank - 30 Amp - 12V
- Search Results: rv steps
- Video: Complete Breakdown of the Mighty Cord RV Power Cord
- Search Results: travel trailer steps
- Q&A: Recommended 8' long 7-Way RV Style Trailer Connector w/ Molded Cable
- Video: DIY Install: MORryde Safe-T-Rail Telescoping RV Hand Rail on your 2022 Jayco Eagle HT Fifth Wheel
- Shop: Nerf Bars - Running Boards
- Q&A: Will The MORryde StepAbove RV Steps # MR48RR Be Compatible With A 1/4" Threshold To Door Gap
- Q&A: Lippert SolidStep Triple Step That Fits 24-1/2 Inch Door
- Q&A: Troubleshooting SolidStep Manual Fold-Down Steps Preventing Door From Closing on Travel Trailer
- Video: MORryde StepAbove RV Steps for 23-3/4" to 26-1/4" Wide Doorways Spec Review
- Video: Review of MORryde RV Steps - Flip Tread RV Steps - MR62UR
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Search Results: trailer tires and wheels
on RV Steps
Rodney
7/7/2024
Hello Jesse M, Upon calling Lippert, I found out that the under the scree door sealer was to small (less than a quarter inch). My camper is older, thus the step would not work. The Lippert representative that I spoke to said that under no circumstance should I trim off the bottom of the screen door. Newer campers have around a 3/4" seal under the screen door and these steps are made for them. Thought your team should know this. Thank you,