Availability of Replacement Foot for Lippert Level Up Jack System

Question

Question:

Have auto Jacks, both rear feet are bent, name on jack is Level Up, can I but feet? Only

asked by: Mark M

0

Expert Reply:

Hey Mark, we do have a replacement foot pad for your Lippert Level Up system with the part # LC324269.

expert reply by: Jameson C

0

Answer 1

I suggest using a strap wrench to hold the cylinder side while tightening the installation hardware on the Replacement Foot Pad, #LC324269.

view full answer...

Answer 2

Yes, the Replacement Foot Pad for Lippert Hydrualic Leveling System #LC324269 will work with your Lippert Level Up system, on your 2018 Coachman SportsCoach 407FW. I have attached a picture of this foot pad being used on a Level Up system.

view full answer...

Answer 3

You will need the Replacement Foot Pad #LC324269 for the Lippert Hydraulic Ground Control Leveling System on your 2018 Forest River Sunseeker 3010DS. The SnapPad XTRA Jack Pads #SP54FR4 will fit your jacks if you do not already have pads for the…

view full answer...

Answer 4

The Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System #LC324269 doesn't have a specified weight rating. Since this is a direct replacement for a hydraulic jack that does have a weight rating, like the 8K Lippert Level Up…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 12

Hey Jeff. There is definitely a correlation between weight and capacity. I've listed the weight of all three of the Power Mountain Tallboy Off-Road Bottle Jacks we have below: Power Mountain Tallboy Off-Road Bottle Jack - 7-15/16" to…

view full answer...

Availability of Replacement Foot for Lippert Level Up Jack System

Product Page this Question was Asked From

Continue Researching