Replacement Foot Pad For Lippert Hydraulic Leveling On a 2018 Forest River Sunseeker 3010DS RV

Question

Question:

I need to replace the landing pad on the leveling system on my 2018 Forest River Sunseeker 3010DS. Can you tell me which ones are the correct ones. They are not welded on they are the bolted kind with a 9 circle.

asked by: Sandra M

1

Helpful Expert Reply:

You will need the Replacement Foot Pad # LC324269 for the Lippert Hydraulic Ground Control Leveling System on your 2018 Forest River Sunseeker 3010DS.

The SnapPad XTRA Jack Pads # SP54FR4 will fit your jacks if you do not already have pads for the jacks. These stay mounted on the jacks so you will not have to crawl under your RV to place and retrieve any pads.

expert reply by: Bud M

1

Serial Number Of Lippert Hydraulic Jack On 2018 Forest River Sunseeker 3010DS
(click to enlarge)

Answer 1

The exact replacement foot plate for the Level Up system you have is not available as a replacement. But you could use #LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you would have to use a 1/2 inch bolt that will…

view full answer...

Answer 2

I suggest using a strap wrench to hold the cylinder side while tightening the installation hardware on the Replacement Foot Pad, #LC324269.

view full answer...

Answer 3

Yes, the Replacement Foot Pad for Lippert Hydrualic Leveling System #LC324269 will work with your Lippert Level Up system, on your 2018 Coachman SportsCoach 407FW. I have attached a picture of this foot pad being used on a Level Up system.

view full answer...

Answer 4

Hey Mark, we do have a replacement foot pad for your Lippert Level Up system with the part #LC324269.

view full answer...

Answer 5

The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube…

view full answer...

Answer 6

Lippert does not recommend using ATF Type F Fluid as it is not compatible with Lippert hydraulic system #LC251910 seals because they will not work properly. The following automatic transmission fluid (ATF) recommendations for use in Lippert…

view full answer...

Answer 7

There are adapters on the market that can go from a cigarette lighter style plug that the #C-FOS07TAPK-006 has to USB/USB-C ports but we don't currently offer any so the only solution I can provide is the #RM-9332. This is a replacement outlet…

view full answer...

Answer 8

Hey TJ, I went out and opened up one of the Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System #LC324269 boxes and found that they include a 5/8-18 x 1-1/2" fine thread grade five bolt. I then called Lippert and they…

view full answer...

Answer 9

You'll have to hold the leg of your jack still so that you can unscrew the bottom of the foot pad to replace it. If you have a large set of channel locks you could do this pretty easily with them. The trick will be hold it tight enough to keep it…

view full answer...

Answer 10

I understand your concern. I called Lippert to verify that the 132 Ft-lb of torque and use of Locktite is still valid. They said that was the requirement and there were no alternative instructions. The assumption is that this is the method they used…

view full answer...

Answer 11

The Replacement Foot Pad #LC324269 that you referenced uses (and includes) a threaded 7/16" bolt for mounting. The mounting hole itself is just about 1/2" in diameter.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Replacement Foot Pad For Lippert Hydraulic Leveling On a 2018 Forest River Sunseeker 3010DS RV

Product Page this Question was Asked From

Continue Researching