Who Makes the Loadstar ST215/65R17 Radial Trailer Tire

Question

Question:

Is this tire manufacturer Karrier or Kenda: Kenda Loadstar ST215/65R17 Radial Trailer Tire The description mentions Karrier

asked by: Rod K

0

Expert Reply:

Great question, Rod!

The Kenda Loadstar ST215/65R17 Radial Trailer Tire - Load Range C # KE88XR is made by Kenda. This company also produces a tire called the Karrier and this is just a typo. I've sent in an update so this will be fixed shortly - thanks for reaching out!

expert reply by: Jon G

0

Answer 1

Based on you confirming that the Karrier ST205/75R14 Radial Trailer Tire #AM10234 matches the tire size that you have these should be the correct tires that you need. There are different load ratings available for the 205/75-15 tire size that you…

view full answer...

Answer 2

A standard 5-way like the part #HM47910 would work great to replace what you have. You'd just run all of the white wires that you have (all three) to the single white wire of this connector, both the brown wires to the single brown of the…

view full answer...

Answer 3

What you have is a wishbone style of 5-way that has the ground and running light circuit split for either side of the trailer. You can replace this setup with one that has a single wire by running both of the wires on the trailer side to the new…

view full answer...

Answer 4

If you check out the attached dimensional photos of the Brophy Trailer Stake Pocket Spare Tire Carrier #SPTC you can see that the mounting plate sits about 6-1/2" away from the portion that sits in the stake pocket. You will simply need to hold…

view full answer...

Answer 5

I spoke with my contact at Optronics about the 5-Way to 7-Way part #A57CCB and the dimensions are: Stretched length of cable from plug to plug is 72 inches 5-way flat plug to coil is 17 inches 7-way round plug to coil is 7 inches Coil length is 8…

view full answer...

Answer 6

Currently the only wiring harnesses we have with a 5-way flat connector are like the 25 Ft 5-Way Trailer Wiring Harness #A25W5B and 40 FT Harness #A40W5B. These harnesses use 6 wires coming from the connector. It has a short 5' blue wire to run…

view full answer...

Answer 7

Hey Rich, so the great thing about trailer tires like the Kenda Loadstar #KE88XR that you have is that the pressure you need to inflate them to is always the same. You need to inflate them to their max PSI when they are cold and you are good in all…

view full answer...

Answer 8

The function you are referencing is reverse lockout, which would be found on a 5-way connection that looks very simliar to a 4-way. Assuming you have a 5-way, what you are looking for is a 7-way to 5-way adapter since you have surge brakes. I…

view full answer...

Answer 9

Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.

view full answer...

Answer 10

For new 5-way wiring what you'll need is the part #A40W5B. This will handle all of the wiring that runs from the connector back to the lighting assemblies as well as for a reverse lock out solenoid. Surge brakes don't always require wiring as…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Who Makes the Loadstar ST215/65R17 Radial Trailer Tire

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching