Replacement Fridge Door Shelf for a Furrion Arctic 10 Cu Ft RV Refrigerator

Question

Question:

need a replacement shelf for a Furrion refrigerator. this would be the shelf mounted on the door. Grand Design Reflection 367BHS.

asked by: Bruce S

0

Expert Reply:

Hey Bruce, thanks for reaching out!

It sounds like you're looking for the Replacement Small Door Bin for Furrion Arctic 10 cu ft 12-Volt Built-In RV Refrigerators # FR57VD.

If you have a different Furrion fridge then I recommend checking with your local appliance store to see if they have something that might work as Furrion doesn't have any other fridge door shelf replacements available.

expert reply by: Jon G

0

L B.

7/21/2024

Do you sell the bottom door shelf?

Jon G.

7/22/2024

@LB We have that bin, but Furrion doesn't have the shelves available, so you'll unfortunately need to check with a local appliance store for that.

Laura

8/28/2026

@JonG Do you make the Replacement Small Door Bin for Furrion Arctic 8 cu ft 12-Volt Built-In RV Refrigerators ?

Robin H.

8/29/2026

@Laura the # FR57VD also fits some of the 8 cu ft models so I would double check the dimensions and see if it works for your particular Furrion. It measures 18" long x 3-1/4" wide x 2-3/4" tall with a 16-3/8" attachment length.

See All (7) Replies to L B. ∨

Answer 1

I attached a picture that shows the install instructions for the Lippert Components High-Speed Power Stabilizer Jack #LC298707 that you referenced and in it you'll notice a set distance isn't specified for where it has to install on the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 8

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

Answer 9

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 10

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 11

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 12

Hey Ian, great to hear from you again! The differences between the MORryde CRE3000 #MR87ZR and AllTrek 4000 #MR89DR that fit a 33" wheelbase is the height between the hanger and equalizer bolts, and the amount of travel the suspension style will…

view full answer...

Replacement Fridge Door Shelf for a Furrion Arctic 10 Cu Ft RV Refrigerator

Product Page this Question was Asked From

Continue Researching