Recommended Cover for a 2020 Aliner Expedition Camper

Question

Question:

Hello, I am trying to locate a storage cover for A Liner expedition model which has the front bubble type storage area built in. Thank you for your assistance, Bob

asked by: Bob

0

Expert Reply:

I took a look at the dimensions of your 2020 Aliner Expedition Camper. My information shows your camper measuring 18' long x 7-1/4' wide x 5-1/2' tall. With this in mind we are going to have to go with a cover not meant for a pop-up trailer like item # 290-12295 because of the height difference.

I recommend the Adco Olefin HD RV Cover for Travel Trailers up to 18' item # AD37ZR. This cover measures 18' 2" long x 8' 3" wide x 7' 6" tall. It has been built to survive in all climates and has a Olefin top with a breathable material on the sides to help keep moisture from building up.

The Adco item # AD37ZR has integrated straps and ropes that prevent the cover from flapping in the wind and damaging your trailer. This is going to be especially helpful with your Aliner due to the height difference. It also includes weighted straps that buckle underneath your trailer to secure the cover.

expert reply by: Jerred H

0

Answer 1

Hi Brian! Having a cover that is breathable is definitely important. If it isn't, mold can form and you really don't want that. That said, if you are in a dryer area of the country, it is a little less important than if you are in a more…

view full answer...

Answer 2

For a cover to fit your 15 foot Aliner, I recommend the Camco UltraGuard Pop-Up Camper Cover #CAM45764. This cover is designed for campers that are 14 to 16 feet long and has a generous width of 7-1/4 feet that should have no problem accommodating…

view full answer...

Answer 3

Thanks for reaching out, Robert! The best way to add a plug-and-play style 4-Way/7-Way connector to your 2023 Honda Passport is with the following parts: - Curt T-Connector Vehicle Wiring Harness #CU86FR - 7- and 4-Pole Trailer Connector Socket…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…

view full answer...

Answer 12

Hey Jim! Unfortunately, your experience is pretty common with RV covers. Constant UV exposure is hard on any cover, and most don't significantly outlast their warranty period. The Classic Accessories PolyPro III #052963793635 uses a triple-ply…

view full answer...

Recommended Cover for a 2020 Aliner Expedition Camper

Product Page this Question was Asked From

Continue Researching