Is The Reese Sway-Control Bracket Compatible With The Curt Ball Mount # C45030

Question

Question:

What is the width of the ball mount on Curt Ball Mount for 2inch Hitches - 1inch Rise, 2-1/4inch - 7-5/8inch Long - 7,500 lbs? Is it compatible with Reese Sway-Control Bracket for 2inch Ball Mounts - Class III and IV Item # RP26003?

asked by: David

0

Expert Reply:

Hi David,

The Curt Ball Mount for 2" Hitches # C45030 is approximately 2-1/2" wide. The Reese Sway-Control Bracket # RP26003 can fit ball mounts that are smaller than 2-5/8" wide so these two components would be compatible with each other.

expert reply by: Kevin C

0

Answer 1

Yes, you can install the ball of the Curt RockerBall 2-5/16" Shock Absorbing Hitch Ball and Ball Mount w/ Sway Control Tab #C45WR in the rise position if you wanted which would give you the rise of 3/4 inch that you mentioned.

view full answer...

Answer 2

While there is no way to attach an anti sway system to the Glyder for Gen-Y part #325-GH-12005. I do have a solution for you. You can use the Convert-A-Ball Dual-Cushioned, Adjustable Ball Mount part #CAB-UM which isn't as clean looking of a…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Stephen! The dealer is right but you can get around this and still use the Curt #C92WR. This isn't just an issue with your vehicle, almost all new vehicles have those rear sensors and they will pick up something like a 4-bike rack because it…

view full answer...

Answer 5

Hey Lee, the Curt hitch part #C93MJ that fits your 2021 Nissan Murano S does fit without any modifications to the body or require any drilling. You do have to remove the tie down bracket though but that isn't too bad at all. What are you planning…

view full answer...

Answer 6

Hey Colleen, congrats on the new SUV. To install a hitch on your 2026 Volvo XC60 Plug-In Hybrid, I recommend the Draw-Tite item #76194. This custom fit class III hitch will bolt directly to your car with included hardware. It has a 2" receiver…

view full answer...

Answer 7

The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…

view full answer...

Answer 8

Hey Eric, yes the Curt hitch part #C37RV does fit the PHEV versions of the 2026 Kia Sorento like you have so it would work great. I attached a picture of a review from a customer that installed it on a PHEV for you to check out as well. Are you…

view full answer...

Answer 9

It sure is Rob, and congrats on the new SUV. The Oris Trailer Hitch with Detachable Hitch Receiver item #TS76VR is definitely comparable to the Stealth Hitches item #SH87FR. It's got the same kind of removable receiver that works great with a…

view full answer...

Is The Reese Sway-Control Bracket Compatible With The Curt Ball Mount # C45030

Product Page this Question was Asked From

Continue Researching