Does Curt Rockerball Fit Curt Aluminum Ball Mount # C45296

Question

Question:

Does Item # c40047 fit Item # C45296? Thanks

asked by: Tracy G

0

Expert Reply:

Yes Tracy, the Curt Rockerball part # C40047 does fit the Curt aluminum ball mount part # C45293 that you referenced.

expert reply by: Jameson C

0

Answer 1

From the base of the #C40047 up to the top of the ball measures 4.091 inches. This is about 1-3/8 inches taller than a standard ball.

view full answer...

Answer 2

Great question! Very smart to lock nice equipment like this. The Shocker Gooseneck Hitch Round #SHK56YR has a built-in spring-loaded Demco eZ-Latch, which works great with most gooseneck locks like the InfiniteRule #IR66FR . If you’re parking in…

view full answer...

Answer 3

Hey Ozzie, since the Weigh Safe Hitch W/ Built-In Scale #WS56KR has a 1" ball shank hole you can use any hitch ball with that diameter like the 2" Hitch Ball #63845 which has a 2" diameter and a 7,500 lb capacity. If you have any other…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hello Dave, The issue that I am running into is the width, and finding something in aluminum. The options we carry are 10" wide, in either cold rolled steel or galvanized. Here are the part numbers we have available: - Single Axle Jeep Style…

view full answer...

Answer 6

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 7

The Curt RockerBall Anti-Rattle Towing Kit #C43KR takes the additional height of the base of the RockerBall into account for the listed 4" rise and 5" drop. I have attached an image below showing how it is measured. Typically, you find the…

view full answer...

Answer 8

I attached an FAQ that details how to pick out the correct ball mount. Picking out the correct ball mount will allow your trailer to sit as level as possible. Basically you will first measure the height from the ground to the top of the receiver…

view full answer...

Answer 9

The Curt Rockerball Shock Absorbing Hitch Ball has anti-Rotation Plate that is not compatible with all hitch mounts. This hitch ball is recommended to be mounted onto standard ball mounts not shock absorbing ones. I recommend the Curt RockerBall…

view full answer...

Answer 10

You are correct the Curt RockerBall Shock Absorbing 2" Hitch Ball - 1" Diameter Shank - Chrome - 7.5K part #C40047 does have a rise. On a standard hitch ball it sits flush with the ball mount but the RockerBall has the included height of…

view full answer...

Answer 11

We have the perfect solution for you with the Curt RockerBall, part #C29FR for 2-5/16" ball or #C40047 for a 2" ball. It completely changes your towing experience by reducing jerking and jarring while towing. It absorbs the movement and…

view full answer...

Does Curt Rockerball Fit Curt Aluminum Ball Mount # C45296

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching