Does The Curt T-Connector Vehicle Wiring Harness # C73VV Fit All 2023 Nissan ARIYA Trim Levels

Question

Question:

Will this harness fit all 2023 Nissan Ariyas? I have a 2023 Nissan Ariya Premier. Thank you.

asked by: Bill J

0

Expert Reply:

Hi Bill,

Yes, the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C73VV is a confirmed fit for all trim levels of the 2023 Nissan ARIYA. If you don't already have the trailer hitch picked out then I recommend the Curt Trailer Hitch Receiver # C64ZV as well.

expert reply by: Kevin C

0

Answer 1

Hey Wesley, thanks for reaching out, and good question. First off, the EcoHitch Stealth Trailer Hitch Receiver #EH74CR is the correct fit for your 2025 Nissan Ariya Platinum Plus. The receiver will partially block the foot sensor, but the sensor will…

view full answer...

Answer 2

Hey Cuong! Congratulations on the new vehicle and thanks for the compliment. We rely on customers to bring those vehicles in so the installation videos can be made to help everyone out. Unfortunately, we haven't had anyone bring in a Nissan Ariya…

view full answer...

Answer 3

Hello Brian, thanks for reaching out. The EcoHitch for the 2023 Nissan Ariya, part #EH74CR has a 3,000 towing capacity and 300 lb tongue weight capacity. If you are looking for the actual lifting weight of the hitch itself, it weighs 47 lbs.

view full answer...

Answer 4

We do indeed have a trailer hitch receiver fit for a Nissan Ariya, with the correct hitch being the following part number: - Curt Trailer Hitch Receiver #C64ZV I verified this fit directly with the manufacturer for you.

view full answer...

Answer 5

Hey Marcelo, Curt has a picture in the instructions showing where to cut the rear fascia on your Aryia, which I've attached a below. Having watched and done numerous installs myself I will say that I never cut the fascia without first holding it…

view full answer...

Answer 6

The 1 Bike Add-On #KU57FR allows you to add an additional bike to the Kuat Transfer V2 Bike Racks 1-Bike #KU64FR, 2-Bike #KU84FR or 3-Bike #KU24FR racks. The 1-Bike Add-On TSAOB is for the previous V1 version of the Kuat Transfer. The mounting…

view full answer...

Answer 7

Nope, there is no drilling required whatsoever on your 2023 Nissan Ariya to install the Curt Trailer Hitch Receiver #C64ZV.

view full answer...

Answer 8

The 1 Bike Add-On #KU57FR allows you to add an additional bike to the Kuat Transfer V2 Bike Racks 1-Bike #KU64FR and the #TSAOB is for the older V1. The easiest way to tell which version you have is look at the shank that slides into the vehicle…

view full answer...

Answer 9

The Yakima Replacement T-Bolt with Nut for Yakima Rack and Roll Trailers - Qty 4 #Y8880184 will fit in the channels of your HD bars, but for the most part, crossbar mounted accessories will come with (or have available) T-channel hardware that will…

view full answer...

Answer 10

Hey Carmelo! Installation of any custom hitch like the #DT26KV or #C64ZV will require trimming. Unfortunately, there is really no way around it for your 2024 Nissan Ariya. Were you planning on towing or do you need it for accessories like a bike…

view full answer...

Answer 11

No need for adapters! The clamps on the Yakima ForkLift Roof Mounted Bike Rack #Y02098 can be adjusted to fit round, square, or aero bars. The Yakima JetStream crossbars #Y00425 are a little large at 3-1/8" wide x 1" tall so it will be a…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Does The Curt T-Connector Vehicle Wiring Harness # C73VV Fit All 2023 Nissan ARIYA Trim Levels

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching