Wear Sleeve To Use With The XLPROLUBE1980KIT

Question

Question:

Can you recommend a wear sleeve that would work with the oil seals,

asked by: Joel

0

Expert Reply:

The Kodiak XL ProLube Kit # XLPROLUBE1980KIT is designed to work with most 3,500lb axles that use a # L68149 inner bearing and a # L44649 outer bearing. The corresponding wear sleeve is the Spindle Grease Seal Set # BB60010. The seals included with this kit would be used in place of the rubber seals that come with the # XLPROLUBE1980KIT.

expert reply by: Jesse M

0

Answer 1

We sure do. You'll need the #BK2-100 which provides an L44649 and L68149 bearing assembly, a L44610 and an L68111 race and a 10-19 grease seal (same as the GS-1917 you mentioned). The tang washer and cotter pin are also included. Each kit…

view full answer...

Answer 2

From what I was able to find it looks like the 4440170 is the #L68149 and the 4440160 is the #L44649 bearing. We don't have anything that matches the dimensions on that seal, the closest thing is the 10-19 seal #RG06-050. This has an inner…

view full answer...

Answer 3

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 4

Hey Mike, yes the replacement cap part #T097-022-00 that you referenced is the correct replacement cap for a Dexter Model A-60/A-75 brake actuator like it sounds like you have.

view full answer...

Answer 5

The choice of oil bath or regular hubs is up to the manufacturer. They are usually found on higher capacity axles, though as you know there are some on lower capacity axles. You can convert some hubs from grease to oil bath using a kit such as…

view full answer...

Answer 6

According to my research you need a replacement hub from Dexter Axle which means you'll need to replace evrything so everything is the same brand and matches correctly. To replace your hub/rotor you should be able to use the Dexter Disc Brake…

view full answer...

Answer 7

Yes you can go the route you mentioned. You'd need to install an idler Dexter 8k Nev R Lube hub with part #004-402-90 on your spindles and then you could use a slip on kit like the part #K71-635-90 and you'd be set.

view full answer...

Answer 8

It definitely is Landon! The Kenda Karrier KR53 ST205/75R15 Radial Trailer Tire item #KE94WV is a load range D tire that will work great on the highway for a long trip. It has a 2,200 lbs capacity per tire and a maximum speed 87 mph. The 15"…

view full answer...

Answer 9

I really wish we did but at this time we do not. But do you happen to know what size bearing cartridge your hubs use? Looks like we have the 8k size and 6k size but nothing on the 7k. Hopefully its' 50 mm though.

view full answer...

Answer 10

Thanks for the pictures! Since your UFP Gold Series oil bath hubs have a 1.98" outer bore then yes, the Kodiak XL ProLube Oil Bath Hub Body and Cap item #xlprolube1980 would work for your boat trailer. The directions say to fill to…

view full answer...

Wear Sleeve To Use With The XLPROLUBE1980KIT

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching