Do Brake Pads of DeeMax Disc Brake Kit # DE22FR Have Stainless Steel Backing

Question

Question:

Does the DE22FR brake kit come with SS on back of pads?

asked by: Neil M

1

Helpful Expert Reply:

Yes, the brake pads that come with the DeeMax disc brake kit part # DE22FR are stainless steel backed. For replacements you'd want the part # DE98VR.

expert reply by: Jameson C

1

Answer 1

The Titan surge brake actuator part #T4843300 that you referenced would work well for you. It's a disc brake actuator and it's zinc coated as well which means it will fight saltwater corrosion.

view full answer...

Answer 2

There's a couple pieces of information you will need to know to determine if the Titan Disc Brake Kit #T4843300 that you referenced would fit your Stehl Tow Dolly ST80TD. The first thing you will need to know is the bolt pattern of your current…

view full answer...

Answer 3

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

view full answer...

Answer 4

In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information as we don't have a way to pull up what your trailer would have. The first thing you will need to know is the bolt pattern of…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Do Brake Pads of DeeMax Disc Brake Kit # DE22FR Have Stainless Steel Backing

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching