Mount: Mounting Bolts and Hardware for 10" Brake Assemblies on a 1917 Ford Model T Video

Yes, the mounting brackets included with the DeeMaxx Disc Brake Kit #DE72FR are also stainless steel.

Hello Dave. I recommend the DeeMaxx Disc Brake Kit #DE28YR. This uses a corrosion-resistant Maxx coat finish, which is similar to Dacromet or Zinc only better. So not as expensive as stainless, but still good rust resistance. These hubs have a 6 on…

To get the Dexter Zinc-Plated, Leverlock Coupler #T4845000 in a higher weight rating you'll need to bump up to a hydraulic actuator like what we see with part #DX89FR which has a 7.5K weight rating. For an alternative standard coupler solution I…

Riveting the linings on brake shoes on hydraulic brake assemblies was historically the industry standard, while electric brake assemblies typically have the pads glued or bonded into place. All Demco could tell me is that they rivet all of their…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

45 to 50 lbs is the recommended torque rating for the 4 bolts that hold 10 inch brake assemblies to a trailer like the part #AKEBRK-35L-SA.

Trailer axle nuts don't have a torque rating as you don't want to run them down super tight. The trick is to tighten the nut till there's no play in the hub in and out with the wheel installed and then use the cotter pin to hold the nut…

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

Going to electric over hydraulic is probably a bit of overkill, and disc brakes will serve you very well, but without the locking up. So that's the route I recommend, and since you have a 5 on 4-1/2" bolt pattern it is likely you have a…

Yes, the Dacromet/Stainless finish on the 10" Kodiak Disc Brakes #KOD67FR is arguably the best for boat trailers since it's the most resistant to rust and corrosion, although it's still a good idea to hose down your trailer with clean…

The Timbren Axle-Less Trailer Suspension System #ASR3500S06 is our only 3,500LB axle option for your 2021 Grand Design Imagine 21BHE XLS travel trailer. Otherwise you will have to order a custom axle as the only axles we have which have the same…