Can The High Pointe Microwave # HP94ZR Be Vented To The Outside
Updated 06/12/2024 | Published 12/04/2023 >
Products Featured in This Question
Question:
Can this microwave be vented to outside?
asked by: Maureen
Expert Reply:
The High Pointe Over the Range RV Convection Microwave # HP94ZR can be vented outside but you'd need to pick up a bit of ducting and duct tape from your local hardware store to connect the vents on the top of the unit to an exterior vent. If you don't already have an exterior vent then we currently offer one in white # V2111-13 and black # V2111-55.
You'll want to pick up some butyl tape # AL28FJ and some non-sag sealant # 344270341437-1 for a waterproof connection to the trailer wall.
Product Page this Question was Asked From
High Pointe Over the Range RV Convection Microwave - 900 Watts - 1.5 Cu Ft - Stainless Steel
- RV Microwaves
- Convection Microwave
- Over-the-Range Microwave
- 1450 Watt Output
- 900 Watt Output
- 1.5 Cubic Feet
- 29-15/16W x 15-11/16T x 15D Inch
- Stainless Steel
- High Pointe
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement RV Microwave for High Pointe EC942K9E
- Q&A: Looking for Replacement RV Microwave for Sharp R-1881LSY
- Q&A: Recommended Replacement For A High Pointe EC942K9E Microwave Oven
- Q&A: Replacement Microwave for my High Pointe EC942K9E in Stainless
- Q&A: Troubleshooting A Blown Internal Fuse In A High Pointe RV Microwave
- Q&A: Do You Have A Replacement For The Furrion FMCM15SS Microwave That Is A Different Brand?
- Q&A: Identifying Lead/Follow Leg on Lippert Level Up RV Leveling System
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Repair an RV Roof
- Article: How Much Solar Power Do I Need For My RV?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups



Glenn
6/11/2024
Our current microwave vents to the inside and we don't have a way to add ductwork to vent outside. In the video I noticed the vents are on the top of the unit, but in the rear of that unit. That seems that it would be venting into the bottom of the cabinet. Is there a variant of this unit that would allow venting internally?