Will a 1up USA Aluminum Quik-Rack 1 Bike Rack Fit a Curt Class I Trailer Hitch on a 2002 BMW 330xi
Published 04/09/2014 >
Question:
Hi! Do you know if the 1up USA Aluminum Quik-Rack 1 Bike Hitch System will fit in this part # C11174 1-1/4inch hitch receiver for a 2002 BMW 330xi? Thank you!
asked by: Vicen C
Expert Reply:
I took a look at the 1up website and the bike rack in question. It does show it fits 1-1/4 inch trailer hitches but does not say if that includes Class I and II hitches or just Class II hitches. Also there were no measurements to determine if the rack would clear the rear of the vehicle. I looked for a phone number to call them but they did not have one listed.
I am certain the rack will fit the hitch # C11174 but what I cannot figure out at this time is if it will clear the rear of the vehicle. When we installed this hitch on a vehicle it measured 6-1/2 inches from the center of the hitch pin hole to clear the rear bumper. If you can contact 1up and determine the rack sticks out far enough then there should be no problem.
If I was going to spend that kind of money on a rack I would go with a Saris Freedom SuperClamp EX, # SA4025F. With it would not have to buy any add-ons to carry more than one bike. It also has an integrated cable lock and a locking anti-rattle hitch pin. It weighs only 28 pounds and it is made in the USA. And I know for sure that it will fit the hitch.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Curt Class I Trailer Hitch Step-By-Step Installation - 2016 Ford Fiesta
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Q&A: Trailer Hitch Receiver Fit For 2019 Ford Fiesta ST
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Hitch Receiver Adapter 1-1/4" to 2" Hitch - 6-1/2" Long
- Shop: Curt Trailer Hitch Receiver Adapter - 1-1/4" (Class II) to 2" - 6" Long
- Shop: Trailer Hitch Adapter - 1-1/4" to 2" Hitch - 4-1/2" Drop/5" Rise - 6-1/2" L
- Q&A: Recommended Crossbars for a 2024 Subaru BRZ With a Bare Roof
- Shop: etrailer Classic Base Plate Kit - Fixed Arms
- Shop: EcoHitch Hidden Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Video: Setting up the etrailer Trailer Hitch Receiver on a 2015 Subaru XV Crosstrek
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: trailer wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Search Results: trailer tires and wheels
- Q&A: Recommended Bike Rack and Dual Hitch Adapter for Carrying E-Bikes While Flat Towing
- Article: How to Choose the Right Trailer Hitch Class
- Video: The Low-Down on the Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Q&A: Which is Better Roadmaster or Blue Ox Tow Bar
- Shop: Brake Controller
- Video: Installing the Curt Trailer Hitch Receiver on a 2025 Toyota RAV4
- Search Results: trailer jack
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Video: Curt Mounting Bracket for 4-Pole Flat Trailer Connector Review
- Search Results: trailer lights


