Does Xtreme Off-Road Trailer Jack Come With Bearings Installed

Question

Question:

Re. this item: Xtreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels - Sidewind - 7 Lift - 770 lbs - Zinc Item # ORJW350D: I read a post where the bearings do not come installed in the wheels for this product and that the customer would have to install them. The post was a couple of years old. Is this still the case with these wheels?

asked by: Jack W

1

Helpful Expert Reply:

The Xtreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels # ORJW350D does not come with the bearings installed. You can use something like a rubber mallet or a block of wood and hammer to tap them into place until they are flush.

expert reply by: Robin H

1

Answer 1

I recommend using the Xtreme Off-Road Swing-Up Trailer Jack #ORJW350D as we do not have a jack which will fit the same weld on bracket you have on your boat trailer. This jack can be bolted onto your frame and will allow you to have more…

view full answer...

Answer 2

The advantage of the Extreme Off-Road Swing-Up Jack with Dual Wheels - Zinc #ORJW500D is getting that higher 1,100 lb capacity and the bigger 10-3/4" lift. This is great for longevity purposes, especially if you'd like to move the jack to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Yes, the Extreme Off-Road Swing-Up Jack w/ Dual Wheels iItem #ORJW500D will work for your T@B 400 Tear Drop Trailer. It looks like your trailer comes with an a-frame jack. You would need to ensure you have enough space on your tongue to accommodate…

view full answer...

Answer 6

I have attached two diagrams below with the dimensions for the XO350 and XO750. Both of these use a bolt on installation so you really only need to know the height of your tongue to see if it is compatible. The #ORJW350D fits 2" to 6" tall…

view full answer...

Answer 7

Hey Justin, welcome back! I can help with that. For the Ark Jacks #ORJW750BD and #ORJW750D, the only difference between the two is the color. The BD is black and the D is silver. Aside from the finish they are the same 1,650 lb capacity 18" lift…

view full answer...

Answer 8

The ARK #ORJW500D Off-Road Swing-Up Jack weighs in at about 32 lbs. The fully retracted length from the center of the pivot the the bottom of the wheels is 11.22 inches. The same distance when fully extended is 18.89 inches, as you can see in the…

view full answer...

Answer 9

With the ARK Xtreme Off-Road Swing-Up Jack #ORJW500D in its lowest position it is 6.49" from the center of the mounting point to the top of the jack. The other end of the jack when fully retracted is going to be 18.89" from the mounting…

view full answer...

Answer 10

The mounting plate on the ARK Removable Extreme Off-Road Swing-Up Trailer Jack #ARK57FR is 5-1/2" wide and 7-1/2" tall. It is designed with several bolt hole patterns(see image) to fit trailer tongues from 2-6" tall.

view full answer...

Answer 11

The Xtreme Off-Road Swing-Up Jack w/ Dual Wheels #ORJW500D and #ORJW350D are pretty similar with the only differences being the weight capacity, 1,100 lbs vs 770 lbs, and the total travel, 18-3/8" vs 12". Aside from that the mounting…

view full answer...

Does Xtreme Off-Road Trailer Jack Come With Bearings Installed

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching