Replacement Master Cylinder Parts For Titan Model 60 Brake Actuator

Question

Question:

My fill cap is stuck, i put liquid wrench to try to loosen but will not budge. do you have a recomendation to remove the cap. it seems my only option is to cut it out. hopefully their is another option.

asked by: Wayne B

0

Expert Reply:

I would recommend using a spray lubricant like WD-40 to try and loosen the cap on the master cylinder of your coupler actuator. Using a tool like vise-grips should allow you to remove the cap from the housing.

If you are able to remove the cap and find it needs to be replaced, you would order part # T4480701.

If you are still unable to remove the cap, we offer replacement master cylinders for the Titan Model 60 coupler actuators. If you have drum brakes on your trailer and you have a Model 60 actuator, the replacement kit is part # T4395100. If you have disc brakes on your trailer, the replacement kit is part # T4820000.

The replacement kits contain the master cylinder, filler cap, connector and hardware needed.

expert reply by: Jeffrey L

0

Answer 1

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Answer 2

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 3

Hey Mike, yes the replacement cap part #T097-022-00 that you referenced is the correct replacement cap for a Dexter Model A-60/A-75 brake actuator like it sounds like you have.

view full answer...

Answer 4

Hi Christopher! If you’re measuring 10-1/2" center-to-center on the mounting holes, the Dexter Torflex Lift Kit #K71-725-02 is very likely not going to bolt up to your brackets as-is. That kit is made specifically for Dexter #12 Torflex torsion…

view full answer...

Answer 5

Hey Tom, thanks for reaching out. Wheel compatibility actually comes from the hub since the surface area on the hub is what determines the wheel size. So, if your trailer already uses 10" drums and 13" wheels, there will be no problem using…

view full answer...

Answer 6

I did some research on your 2006 Marine Master Tandem Axle Trailer and found some of the UFP part lists. Dexter owns that company as well as the Kodiak line, so the parts are extremely similar with different part numbers that should work very well as…

view full answer...

Answer 7

The easiest way to bend the tabs of brake pads like the #K225CP that you referenced is to install the pad and caliper, put a big screwdriver or chisel between the hub of the brake rotor and the bottom of the pad to keep the bottom side pushed up…

view full answer...

Answer 8

Hey Brian, yes the grease seal of the Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles #AKHD-545-35-EZ-K is designed to prevent grease from getting on the brake components. But what I would guess happened to you is that you overfilled the hub…

view full answer...

Answer 9

Hey Steven, thanks for reaching out. It may be possible to add brakes to your trailer. The first thing you will want to verify is that your axle has a brake flange. It should look something like part #4-35. If no brake flange is present, they can be…

view full answer...

Replacement Master Cylinder Parts For Titan Model 60 Brake Actuator

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching