Which Capacity Jack for a 2002 Viking Pop-Up Camper
Updated 03/31/2014 | Published 03/29/2014 >
Question:
I have a 2002 viking pop up and I need to replace the crank jack with wheel but not sure what weight capacity I should get
asked by: Jenny M
Expert Reply:
The capacity of the jack you choose needs to be greater than the tongue weight of the fully loaded and ready to tow trailer. I have linked you to an article that explains some methods of determining your trailer tongue weight. It's a good practice to overshoot the capacity quite a bit over and above the trailer tongue weight, if possible. Leaving plenty of cushion will mean that the jack will be easier to crank and will last longer.
The Fulton # F1411300301 you referenced has a 1500 lb capacity, which should be plenty for a pop-up.
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Weld On - Sidewind - Swivel - 10" Lift - 1.5K
- Trailer Jack
- Boat Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Marine Grade
- 1001 - 2000 lbs
- Manual Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: In-Depth Review of the Fulton Boat Trailer Jack w/ Wheel
- Shop: Fulton Boat Trailer Jack w/ Wheel - Weld On - Sidewind - Swivel - 10" Lift - 1.5K
- Video: Let’s Check Out the Fulton Boat Trailer Jack w/ Wheel
- Video: Checking Out the Replacement Hardware Kit for Fulton Swivel Jacks
- Shop: Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Q&A: Replacement for Shelby Jack on Boat Trailer
- Shop: Bulldog Bolt-Thru Swivel Trailer Jack - Bolt On - Sidewind - 10" Lift - 1,500 lbs - Gray
- Shop: Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - 1.2K
- Shop: Replacement Sidewind Handle Assembly for etrailer and Ram Square, Direct Weld Jacks - 7,000 lbs
- Shop: Ark Xtreme Off-Road Swivel Trailer Jack w/ 2 Wheels - Sidewind - 12" Lift - Zinc - 770 lbs
- Shop: Replacement Hardware Kit for Fulton Swivel Jacks
- Q&A: Replacement Jack Recommendation for Shelby that Bolts to Welded Swivel Mounting Bracket
- Q&A: Fulton Trailer Jack Replacement Hardware Kit
- Q&A: Replacement 1200 Pound Fulton Boat Trailer Jack
- Q&A: Handle Hits Boat Using Fulton XLT Bolt-Thru Swivel Trailer Jack F141132
- Q&A: What is the Measurement of Fulton Marine Jack from the Floor to the Bottom of the Bracket?
- Q&A: Replacing a Shelby 1,000 lbs Trailer Jack With a Similar Fulton Jack
- Video: An In-Depth Look at the Fulton XLT Boat Trailer Jack w/ Wheel


