What Would Cause Trailer Suspension Equalizer to Sit Unlevel
Updated 06/17/2025 | Published 09/26/2023 >
Question:
I have a fifth wheel trailer with 4,000 lb rated axles, the old springs were flat so I recently purchased new 4,000 lb rated springs from e-trailer. After installing them full sets of leaf springs are tilted towards the rear of the trailer about 5°. The equalizer are not level. I didnt know if this was how it was supposed to be set up. Any help would be appreciated
asked by: Edward R
Expert Reply:
It sounds like you installed leaf springs that weren't the correct length for your setup. Looking at your equalizer it looks like your springs are too long. The simplest solution would be to have your front and rear suspension hangers removed and reinstalled further out and that would get rid of the issue. Sometimes a shorter length equalizer can help but for you I don't think there's a way to get a shorter one in there.
Product Page this Question was Asked From
3-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 20-3/8" Long
- Trailer Leaf Springs
- Double Eye Springs
- 2000 lbs
- 1-3/4 Inch Wide
- 3 Leaf
- 20-3/8 Inch Long
- Painted
- etrailer
more information >
Continue Researching
- Search Results: trailer leaf springs
- Search Results: leaf spring
- Search Results: morryde x~factor
- Search Results: mr46zr
- Search Results: trailer shackles
- Search Results: xfactor
- Search Results: x brace
- Shop: Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased
- Shop: MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 2-1/4" Long Shackle Straps
- Shop: MORryde Shock Absorbing Suspension Equalizers for Tandem Axle Trailers w/ 35" Wheelbase - 8K
- Shop: Replacement U-Bolt Axle Mounting Hardware Kit - 3" Axles
- Shop: Replacement Wet Shoulder Bolt - MORryde Suspension Upgrade Kits - 9/16" x 3-3/8" - Qty 1
- Q&A: Trailer Suspension Equalizer Tilted Up At one End
- Q&A: Troubleshooting Trailer Axle Equalizer that Touches Trailer Frame
- Shop: MORryde Suspension Upgrade Kit for Tandem Axle Trailers - 3-1/8" Long Shackle Straps
- Shop: Dexter Heavy-Duty Suspension Kit for Tandem-Axle Trailers - 1-3/4" Wide Double Eye Springs
- Q&A: Should Leaf Spring Capacity Match Trailer Weight or Axle Weight for Best Ride Comfort
- Q&A: Can I Upgrade My 3,500 lb Leaf Springs To 5,000 lb Springs If The Measurements Match?
- Q&A: Demco Coupler for 2-5/16 inch Ball Flat Mount with 3/4 inch Diameter Bolt Holes
- Video: Review of Tie Down Spare Tire Mount - Frame Mount - TD86FR
- Video: Let’s Check Out the Replacement Wet Shoulder Bolt
- Video: Breaking Down the MORryde Suspension Upgrade Kit for Tandem Axle Trailers
- Video: Let’s Check Out the Replacement Equalizer for E-Z Flex Suspension Kits
- Video: MORryde X-Factor Crossmember Installation - 2020 Grand Design Momentum 5W Toy Hauler
- Video: Ultimate Overview of the MORryde Suspension Upgrade Kit for Tandem Axle Trailers
- Video: An In-Depth Look at the MORryde X-Factor Crossmember for Standard Frame Hangers
- Shop: Trailer Wiring
- Q&A: Can Taller Equalizers be Used for Better Clearance Between Suspension and Trailer Frame
- Q&A: Troubleshooting Trailer Tandem Trailer Axles Where One Is Closer to Trailer Frame than Other
- Article: How to Tell the Weight Rating of a Trailer Axle



Jeremy
6/14/2025
My trailer has the same issue right after I replaced my axel will this be a problem using it?