Trailer Wheel Availability With 5 on 4-3/4" Bolt Pattern

Question

Question:

I have a boat that I am trying to get a spare wheel and tire for. It’s a ST175/80R13, but the 5 lug pattern is 4.75in. I can’t find anything on your website that is 4.75in. Can you help?

asked by: Grant

0

Expert Reply:

Currently we only have 15" wheel diameters with the 5 on 4-3/4" bolt pattern like the Wheel # AM38NR.

We do have the Karrier 175/80R13 tires available in a load range C # AM10199 or D # AM10210 if you are able to find the correct bolt pattern wheel for your trailer.

expert reply by: Bud M

0

Answer 1

The most popular trailer wheel bolt pattern is the 5 on 4-1/2 inch bolt pattern and as far as we are aware the bolt pattern you mentioned is not used on trailers at all. So my bet is you probably have the 5 on 4-1/2 inch. I attached a help article…

view full answer...

Answer 2

Hello Kevin, thanks for reaching out. The 5 on 4-3/4" wheels are pretty uncommon these days. We carry only one wheel with this bolt pattern, the Steel Mod Silver Trailer Wheel #AM38NR. This is a 15" diameter 5" wide wheel. This is the…

view full answer...

Answer 3

Hello Andrew. For a wheel in a 15" with a 5 on 4.75" bolt pattern, the only wheel that we carry with those specs is the Steel Mod Silver Trailer Wheel - 15" x 5" Rim - 5 on 4-3/4 #AM38NR, this wheel comes in a silver powder coat…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Trailer Wheel Availability With 5 on 4-3/4" Bolt Pattern

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching