What are Drill Requirements for Use with Trailer Valet JXC Trailer Jack

Question

Question:

Hello....regarding TV94FR Trailer Valet JXC...what size drill not brand are the fellers using with Trailer Valet hex socket?

asked by: Steven V

1

Helpful Expert Reply:

With the Trailer Valet part # TV94FR basically you can use any 18 or 24 volt drill and you'll be fine. Cordless drills are generally rated by voltage and not weight so just make sure yours is at least an 18 volt model.

expert reply by: Jameson C

1

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 3

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 4

Hello Ralph, thanks for reaching out. The etrailer Electric Trailer Jack #e23ZV will be a great option for you. The jack can be rotated to the side if needed. We have one of these jacks on our trailer here at the shop and I have seen it rotated and…

view full answer...

Answer 5

It sure does Steve! Our 3,500 lbs etrailer Electric Trailer Jack w/ Tongue Weight Scale item #e43KV also comes in a 5,000 lbs capacity. We have two different options depending on how you want to power it that I have listed below: Wired to Trailer -…

view full answer...

Answer 6

To determine the correct size RV storage cover for your Coleman Lantern LT Travel Trailer you'll need to measure the body length. In the attached picture below you'll see exactly how to measure. Once you have this measurement you can choose…

view full answer...

Answer 7

Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…

view full answer...

Answer 8

Hi Bill! You will need to completely replace the system since you have old Dometic R410a units on your Monaco. Everything switched to R32 refrigerant following new EPA regulations in 2025, and the new systems are not backwards compatible. For a…

view full answer...

Answer 9

Hey Alan, while the Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners #ADV98SR does have ability to control a furnace it can't be used with a Duo Therm setup like you have. It can only work with Advent Air AC…

view full answer...

Answer 10

Hey Keith! I can definitely help you find a replacement for your Dometic Duo Therm. However, you're going to have to replace the thermostat and air distribution box as well. Your current setup is for R410A and everything switched to R32 last year…

view full answer...

Answer 11

Hey Matthew, thanks for reaching out. We do have a heat strip kit that will work with the Advent Air RV Air Conditioner System #ADV99QR. For that you'll need the following: - Electric Heat Strip for Advent Air RV Air Conditioners - 5,500 BTU -…

view full answer...

What are Drill Requirements for Use with Trailer Valet JXC Trailer Jack

Product Page this Question was Asked From

Continue Researching