Is There a Blank Cover Plate Which Can Mount Over Holes For A-Frame Trailer Jack Holes?

Updated 08/08/2023 | Published 08/06/2023

Products Featured in This Question

Round Snap Ring Swivel Jack w/ Footplate - Bolt On - Black - Topwind - 10-1/2" Travel - 2K

(738)

$72.26

Ultimate Trailer Jack - A-Frame - Topwind - 27-1/2" Lift - 2,000 lbs

(844)

$89.90

Question:

I am considering replacing the existing a-frame jack on our utility trailer with the etrailer 2000 lb topwind swivel jack, # TJBB-2001-B. This would provide additional ground clearance for the jack footplate when towing, as well as allowing our F-150 tow vehicles tail gate to be lowered when coupled to the trailer. This leads to a simple question. Removing the existing a-frame jack will leave a 2-1/4inch hole and three threaded bolt holes in the trailer coupler. Is there available a predrilled blanking plate that can be bolted on to cover the jack hole in the coupler? Thank you.

asked by: Dan

Expert Reply:

I have never seen a blank cover plate to cover the hole on your trailer A-frame, but you should be able to easily fabricate one out of a steel or aluminum sheet. As an alternative to the Snap Ring Swivel Jack # TJBB-2001-B you could also consider the Ultimate Trailer Jack # 322-RDJ-2K. This jack mounts in the same space as your current A-frame jack and will allow you to lower it to one of 7-different heights to clear your tailgate.

expert reply by: Bud M