Solution for a Replacement Battery Pack for AirBedz Built-In Air Pump Not Holding Charge

Question

Question:

I bought a battery, and will not take a charge.

asked by: Jeff E

0

Expert Reply:

The Replacement Rechargeable Battery Pack for AirBedz Built-in Air Pumps # 341025 is recommended to be charged 8 hours for every 20 minutes of use so there is a chance that the battery pack arrived dead, but if it's not able to charge at all then it's defective and would need replacing.

You could try and use the Car Charger Cord for AirBedz Battery Pack # 341024 to see if maybe it was the cable that is bad or if it's the battery. If swapping these cables allows the battery pack to hold a charge then that just means the cables bad and you'll just need to use this replacement cable. If still no dice, then the battery is bad and will need to be replaced.

expert reply by: Bryce D

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Yep, you can get a replacement battery for your AirBedz XUV Air Mattress with Built-In Rechargeable Battery Air Pump #341030, #341031, or #341032; what you will need is the following part: - Replacement Battery Pack for AirBedz Rechargeable Battery…

view full answer...

Answer 4

Yes, the AirBedz XUV Air Mattress with Built-In Rechargeable Battery Air Pump - Blue part #341030 is a confirmed fit for your 2011 Honda CR-V. One of our customers love the mattress for their CR-V. I have attached a couple of photos they sent us. It…

view full answer...

Answer 5

If you check out the 3 minute mark of the review video linked you'll see that the middle of the mattress #341031 is well supported due to the high amount of air pressure in the mattress. It would feel supported in your Highlander.

view full answer...

Answer 6

I have a solution for you that will allow you to make an adapter, but we do not sell one pre-made. To adapt your 9-pin trailer plug to work with the 7-way connector on the truck, you would need the 9-pin vehicle side connector that you referenced,…

view full answer...

Answer 7

There is only one option for a replacement battery for AirBedz mattresses which is the #341025. You can compare this to what you have now but it should match.

view full answer...

Answer 8

If you have the factory 7-way at the rear of your 2003 GMC Yukon (sounds like you do), all you would need to install a brake controller like the part #90885 would be the correct install harness, #3015-P. It will plug into the black junction box under…

view full answer...

Answer 9

For your 2003 GMC Yukon XL, I recommend the Tekonsha P2, #90885. It is one of our most popular controllers because it is easy to set up and use and it offers diagnostics. The P3, #90195, is a great controller but is geared more towards individual…

view full answer...

Solution for a Replacement Battery Pack for AirBedz Built-In Air Pump Not Holding Charge

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching