Can Thule Hullavator Install on ProBar that Sticks Past Feet 15 inches

Question

Question:

I have Thule Pro bars on my Ford F150 bed cap. They extend 15 inches from the foot. Can I install a Thule Hullavator on them? I see Thule recommends 4-8 inches. Does that mean you should not go beyond 8 inches? What is the max distance that the Hullavator should be from the foot?

asked by: David N

0

Expert Reply:

A Thule Hullavator part # TH898 can install on a ProBar that is extended out 15 inches past the feet of the rack. If you can slide the bars more to one side of the roof so that you can get it between 4 and 8 inches you'll be best off as this would prevent the carrier from putting undue stress on the roof rack components.

expert reply by: Jameson C

0

Answer 1

Make sure that you place the bottom section of the Thule Hullavator #TH898 as far up to the end cap of your crossbars as possible. This could be your issue. You can shift the crossbar around if that doesn't solve your problem. With the brackets…

view full answer...

Answer 2

The Thule Hullavator Pro Kayak Roof Rack and Lift Assist w/ Tie-Downs #TH898 is compatible with Thule Wingbar Evo crossbars. I reached out to the manufacturer about the fitment and they said that to use the Hullavator with the Wingbar Evo's, you…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 9

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 10

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 11

Hi Jeff, welcome back and sorry to hear that gave you so much trouble. The Redarc Tow-Pro Link Bluetooth Brake Controller #RED57AR will work on your Silverado. This plugs in-line at the back of your 7-way at the rear of the truck. You can either…

view full answer...

Answer 12

Hey David, the Redarc Tow-Pro Link Bluetooth Brake Controller #RED57AR that you referenced will fit any vehicle that has a 7-way installed on it including your 2017 Ram 3500 that has a factory brake controller. This will bypass that circuit on your…

view full answer...

Can Thule Hullavator Install on ProBar that Sticks Past Feet 15 inches

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching