Recommended Weight Distribution for 2017 Dutchmen Kodiak Ultra-Lite 283BHSL

Question

Question:

I have a 2017 Dutchmen kodiak 283 bhsl that I am planning to pull with a 2001 F350 I brought the unit home without hitch work done due to the cost the dealership was charging for a brand that I will not disclose I was wondering if the reese 49912 wd would be sufficient or if I need something more

asked by: David P

0

Expert Reply:

The weight distribution system you use needs to be rated for the tongue weight of your 2017 Dutchmen Kodiak Ultra-Lite 283BHSL. The # RE94FR has a tongue weight range of 400-800 lbs and your dry tongue weight is 754 lbs so you will easily exceed the capability of the system, making it ineffective.

Based on that tongue weight, the 5,579 lb dry weight of the trailer, and the 7,600 GVWR you need the # RE44FR instead. This has a tongue weight range of 600-1,150 lbs so it will have you covered whether your trailer is empty or fully loaded. I would also recommend getting a scale like the # e99044 so you can measure your loaded tongue weight.

expert reply by: Robin H

0

Answer 1

We have plenty of options for your Reese Pro Round Bar Weight Distribution w Sway Control #RE44FR! I recommend taking a look at the: -Equal-i-zer Weight Distribution Shank #EQ44FR. This shank has 12" of drop and 15" of rise, which is…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Recommended Weight Distribution for 2017 Dutchmen Kodiak Ultra-Lite 283BHSL

Featured Help Information

Miscellaneous Media

Continue Researching