Can You Run Generator While Attached To Stromberg Carlson Tray # CC-255?

Question

Question:

CAN I LEAVE THE GENERATOR ON THIS A FRAME WHILE IT IOS RUNNING?

asked by: Barbara P

0

Expert Reply:

Yes, you can use a generator and leave it installed on the Stromberg Carlson Tray # CC-255. Just make sure you have the generator grounded properly, which is specific to which generator you have but will be listed in it's owner's manual.

However since generators vibrate a lot, you'll probably get quite a bit of noise so I'd personally just remove it and set it on the ground.

expert reply by: Samuel C

0

Answer 1

Easiest way to lock a generator to the Stromberg Bunk carrier part #CC-255 would be to run a cable lock like the part #8218DPS around the base of the bunk and then through the handles of the generator.

view full answer...

Answer 2

There sure is! The RC Manufacturing T-Series Trailer Tongue Tool Box - A-Frame - Aluminum - 2.6 Cu Ft in Silver #350970 or Black #350980 will fit in perfectly in your Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers - 300 lbs…

view full answer...

Answer 3

Hey Doug, That's a good question because fit is really important so the cover stays snug on your trailer, and there is a specific way to measure for the etrailer covers. It's pretty simple, and what you want to do is measure the body of the…

view full answer...

Answer 4

To determine the correct size RV storage cover for your Coleman Lantern LT Travel Trailer you'll need to measure the body length. In the attached picture below you'll see exactly how to measure. Once you have this measurement you can choose…

view full answer...

Answer 5

Hey Daniel, thanks for reaching out. Yes, we do have a wiring harness that will allow you to add a 7-way to the bed of your 2018 GMC Sierra 2500. For the 6-1/2' bed I recommend the following: - Mighty Cord 5th Wheel/Gooseneck Wiring Harness w/…

view full answer...

Answer 6

Hey Tim, of the available RV covers I would recommend the etrailer part #e37VV for your Rockwood Minilite that is 26 foot long for something that is easier to install and provides great protection. How much snow do you guys usually get?

view full answer...

Answer 7

Hey Juan! If your axle spacing is 33" then yes, the MORryde ALLTREK 4000 Shock Absorbing Equalizers #MR89DR will fit your toy hauler. We don't have this information available so you will need to grab that measurement to be sure. I also…

view full answer...

Can You Run Generator While Attached To Stromberg Carlson Tray # CC-255?

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching