Battery Tender/Trickle-Charger Setup for a 6x12 Neo Trailer
Updated 04/21/2023 | Published 04/12/2023
Products Featured in This Question
Question:
There are 2 things I would like to do to my new 6x12 Neo Trailer model NAM126S. This is a 4-wire single axel trailer and was specifically purchased to tow my motorcycle. #1. I will be traveling across country next month and I wanted to install a battery tender to trickle charge the motorcycle while it is being towed. I have a dc to ac power inverter and the trickle charger, but I’m not sure how to go about connecting the power inverter to the existing wiring. #2. I am also thinking about installing a deep cycle AGM battery so that my interior trailer lights will work even when my trailer is not connected to my vehicle. Again, I’m not sure how to do this. In either option above, I’m sure you would have all of the parts I would need in order to accomplish my very short wish list. Thank you
asked by: Carl
Expert Reply:
So it's going to be quite a bit.
What you're going to need is to convert your trailer to a 7-way with a junction box # 38656, and then use a DC to DC charger like the Redarc In-Vehicle BCDC Battery Charger - Single Input # RED96FR to use the vehicle to charge the battery that you're adding to the trailer.
You're then going to need a small inverter, like the Go Power Industrial Pure Sine Wave Inverter # 34279948, and plug the charger # 329-GENIUS10 into that to go to the bike battery.
Product Page this Question was Asked From
Continue Researching
- Shop: Race Ramps FlatStoppers for Vehicle Storage - 3-3/8" Lift - 14" Wide - 6,000 lbs - Qty 4
- Search Results: flat stoppers
- Search Results: wheel cover
- Article: Trailer Wiring Diagrams
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Q&A: Difference Between Pro Series Drop Leg Square Jacks PS1400950376 And PS1400960376
- Q&A: Is Norcold 12V RV Mini Fridge A Good Choice For Lance Truck Camper Off-Grid
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Option For Swapping Out A Lance Proprietary 6-Pole Socket
- Article: Trailer Lighting Requirements
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: How to Remove the Outer Cover of the Ventline Exterior Wall Vent
- Q&A: Recommended Brake Wire for a 14' Long Trailer?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft